Loading ...
Loading ...
Loading ...
5
NOTE:
It is most important that this appliance is installed correctly and that operation is
correct before use. Installation shall comply with local, electrical health and safety
requirements.
Waldorf Electric Pasta Cookers are designed to provide years of satisfactory service and correct installation
is essential to achieve the best performance, efficiency and trouble-free operation.
This appliance must be installed in accordance with National installation codes and in addition, in
accordance with relevant National / Local codes covering electrical, fire safety and health and safety.
Australia / New Zealand: AS / NZS3000 - Wiring Rules.
United Kingdom: BS7671 - Requirements for Electrical Installations.
Installations must be carried out by qualified service persons only. Failure to install the
equipment to the relevant codes and manufacturer’s specifications shown in this section will
void the warranty.
Components having adjustments protected (e.g. paint sealed) by manufacturer, are only
to be adjusted by an authorised service agent. They are not to be adjusted by the installation
person.
Remove all packaging and transit protection from the appliance including all protective plastic
coating from the door outer panel and exterior stainless steel panels.
Check equipment and parts for damage. Report any damage immediately to the carrier and
distributor.
Report any deficiencies to the distributor who supplied the appliance.
Check that the available electrical supply is correct to that shown on the rating plate located on the
inside of the access door.
Check that the following parts have been supplied with the appliance:
PC8140E / PC8140E-7
Baskets 1/6, 165 x 125mm 6
Basket Support Frame 1
1. Any appliance requires adequate clearance and ventilation for optimum and trouble-free operation.
The minimum installation clearances shown below are to be adhered to.
2. Position the appliance in its approximate working position.
3. The legs must always be fitted. Ensure that the legs are securely attached.
NOTE:
Only non-combustible materials can be used in close proximity to this appliance.
In order to facilitate easy operation, drainage and servicing of the appliance, a
minimum of 600mm clearance should be maintained at the front of the appliance.
Left / Right hand side 50mm 0mm
Rear 25mm 0mm
Loading ...
Loading ...
Loading ...