Loading ...
Loading ...
2
SETUP & OPERATION
STEP 1: INSTALL BATTERIES
IMPORTANT: The starter batteries included with this product are for testing
purposes only and should be immediately replaced with new alkaline or lithium
batteries. It is NOT RECOMMENDED to use Non-alkaline or rechargeable
batteries.
1. Remove the battery compartment cover
located on the right side of the control panel
by pushing in and to the right.
1.
2. Insert 4 “AA” batteries (included). Ensure the
batteries are installed in the correct direction,
with regard to polarity (+ and -).
2.
3. If the batteries are put in correctly, the safe will
beep and the LCD readout will flash, then it
will read “GOOD”
3.
4. Once the batteries are properly installed,
replace the battery compartment cover.
4.
REPLACE BATTERIES:
Weak or dead batteries should be replaced
immediately and all 4 batteries should be
changed. To replace the batteries please
follow the instructions in STEP 1. in the
“SETUP” section. Remember to always
remove batteries from safe if not using for an
extended period of time. If your batteries are
completely dead and you cannot open the
safe by using the digital keypad, use the
override access key to open safe and access
the battery compartment.
NOTE: It is NOT RECOMMENDED to use
Non-alkaline or rechargeable batteries.
If the batteries are removed or fail, the keypad memory will NOT be erased
and the active programmed code will still work once power has been
restored.
Loading ...
Loading ...
Loading ...