Ancona AN-17035SS 36" 600 CFM Ducted Wall Mount Pyramid Range Hood in Stainless Steel

Product Manual: - Page 14

For AN-17035SS.

PDF File Manual, 20 pages, Read Online | Download pdf file

AN-17035SS photo
Loading ...
Loading ...
Loading ...
— 14 —
IMPORTANT:
• Observeallgoverningcodesandordinances.
• It is the customer’s responsibility to contact a qualified electrical installer.
• Ifcodespermitandaseparategroundwireisused,itisrecommendedthataqualifiedelectriciandeterminethat
thegroundpathisadequate.A120-Volt,60Hz,AC-only,fusedelectricalsupplyisrequiredonaseparate15-amp
circuit, fused on both sides of the line.
• DONOTgroundtoagaspipe.
• Checkwithaqualifiedelectricianifyouarenotsurethattherangehoodisproperlygrounded.
• DONOThaveafuseintheneutralorgroundcircuit.
IMPORTANT: Save this Installation Guide for electrical inspector’s use.
GROUNDING INSTRUCTIONS:
• Thisappliancemustbegrounded.Intheeventofanelectricalshort-circuit,groundingreducestheriskofelectric
shock by providing an escape wire for the electric current.
• Thisapplianceisequippedwithacordhavingagroundingwirewithagroundingplug.Theplugmustbeplugged
into an outlet that is properly installed and grounded.
WARNING: Improper grounding can result in a risk of electric shock.
• Consultaqualifiedelectricianifthegroundinginstructionsarenotcompletelyunderstood,orifdoubtexistsasto
whether the appliance is properly grounded. DO NOT use an extension cord. If the power supply cord is too short,
have a qualified electrician install an outlet near the appliance.
Installation
STEP 13
Install Chimney
• Place chimney on top of the main housing.
• Remove the protective coating from the upper chimney. Carefully slide the upper chimney down into the lower chimney.
Make sure upper chimney is moving freely.
• Hook lower chimney bracket to lower chimney, then screw the lower chimney bracket onto wall (see Figure 5).
• Either hook the bracket to the upper chimney by matching the side lock (see Figure 6-1),
OR
screw the upper chimney to the upper mounting bracket (see Figure 6-2).
Figure 5 Figure 6-1 Figure 6-2
Loading ...
Loading ...
Loading ...