Loading ...
Loading ...
Loading ...
7
English
overheating is detected. See the “RESET HEATER”
instructions in this guide to determine how to check and
reset the heater.
• If the heater and other electrical products suddenly stop
working at the same time, your home circuit breaker
or fuse may have tripped due to an overload of power.
Consider only running your heater on the “low” setting,
only running one heater at once and unplugging all other
electrical products while running the heater, and/or hiring
an electrician to install an additional circuit to your home’s
electrical system.
SERVICING WARNING — To reduce risk of fire, electrical
shock and injury to persons, observe the following:
- Clean your product regularly, only as is instructed in
this manual. Prior to cleaning, turn off the power on your
product and unplug. Do not use gasoline, thinners, solvents,
ammonias or other chemicals for cleaning. Refer to the
CLEANING instructions provided.
- Do not open appliance housing while product is plugged
in. To avoid risk of shock, all service and/or repairs must be
done by a Vornado Authorized Service Center.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Contact Vornado Consumer Service or dealer or an
experienced radio/TV technician for help.
This Class B digital apparatus complies with Canadian ICES-
003.
Changes or modifications not expressly approved by the
Loading ...
Loading ...
Loading ...