Loading ...
Loading ...
Loading ...
22 English
Allow the unit to fully circulate the heat throughout the room, may take
several minutes.
Power off and unplug the unit. On the bottom of the unit, there is a
gray tip over switch. Push in 4-5 times ensuring it is not stuck. Set unit
down on flat surface. Be sure power cord is not under unit. Plug unit in
and power on. Turn to highest heat setting.
Make sure the CSR is within 15 feet of unit.
Reset the CSR remote to re-establish connection (See CRIB SENSOR
REMOTE).
Replace batteries. Note: Even when Sensa is powered off, to maximize
battery life, it is recommended you turn the CSR remote off (slide
switch to the off position).
Unit is not
producing
sufficient
amount of heat.
(cont.)
Unit power on
but there is no
heat.
CSR remote will
not sync.
Loading ...
Loading ...