Loading ...
Loading ...
Loading ...
3. Push the air purge bulb again and again until fuel
starts to fill the air purge bulb. It is not necessary to
fill the air purge bulb fully.
4. Put the product on a flat surface on the ground.
5. Hold the product with the right hand.
CAUTION: Do not use your feet to
hold the product.
6. Pull the starter rope handle slowly until resistance
occurs.
7. Pull the starter rope handle quickly with the left hand.
Pull the starter rope handle again and again until the
engine starts.
Note: Do not pull the starter rope handle to full
extension and do not let go of the starter rope
handle.
8. If the engine is cold set the choke control to the open
position.
9. If the engine is cold let the engine operate for 2-3
minutes to become warm before operation.
WARNING:
Air is released when
the engine is started and when the
product is set at idle speed. Do not let
persons to come near the product or the
blower pipe.
To operate the product
• Operate the product at usual work hours. Obey local
regulations.
• Decrease the pieces of equipment and select the
correct speed for your task. Use the throttle at lowest
position possible to prevent more noise and dust
than necessary.
• Keep the blower nozzle near the ground.
Note: Husqvarna recommends that you use the
full blower nozzle extension.
• Make a note of the wind direction and operate the
product in the direction of the wind.
• Use applicable garden tools to release material from
the ground.
• In areas with dust, use spray equipment to wet the
area. This decreases the operation time.
• After operation, keep the product in storage
vertically.
To stop the engine
CAUTION: Do not stop the product at
full speed.
• Put the start/stop switch in the stop position.
Maintenance
Introduction
WARNING: Read and understand the
safety chapter before you do maintenance
on the product.
8 1436 - 004 - 27.05.2022
Loading ...
Loading ...
Loading ...