Loading ...
Loading ...
Loading ...
10
OPERATING INSTRUCTIONS COFFEE GRINDING TIPS
SPECIAL FEATURES
MEMORY
After the unit has been set to a desired grind time, it will remember your preferred
time and make that time the new default. The unit will display that time when in
standby mode and will change only when it is reset to another time or unplugged.
After unplugging, the unit will reset to the 5-second default time.
PULSE MODE
For a short, customized duration of grinding, simply press and hold the START/
STOP button instead of setting a grind time. When grinding in pulse mode, the
display timer will count up to a maximum of 40 seconds. When you release the
button, the grinder will return to standby mode.
SOUND
The grinder beeps each time a button is pushed. If you prefer no sound, you can
turn that feature off by holding down the MAX Time button and +5 Sec button
together for 5 seconds. (The LED display will show "OF," indicating that sound is
off.) To turn the sound back on, hold down the same two buttons for 5 seconds.
The LED display will show "ON," indicating that sound is on. Your set sound
preference will be retained even after unplugging.
OVERHEAT PROTECTION
This appliance is equipped with an overheat protective device. It will power
off automatically after running continuously for 3 minutes to protect the unit.
If this happens, unplug the unit, and wait 30 minutes for it to cool off before
grinding again.
• Freshly roasted beans (or newly opened vacuum-sealed bags of beans) will yield
the best avor and aroma.
• To keep coffee beans at peak freshness, store in an airtight container in the freezer
for up to 2 months. NOTE: Coffee beans can be ground frozen.
• Never grind far in advance, and grind only the amount of coffee you will use right
away. Ground coffee loses aroma and avor quickly and attracts other odors.
• Do not allow grounds to exceed the MAX line on the ground coffee container.
Otherwise ground coffee can back up into the machine and block the grinding
mechanism.
TROUBLESHOOTING
Problem Possible Cause/Solution
The error code “E1” appears in the display. The hopper is missing or not properly
attached or locked to the base.
Coffee grounds y out of the container
during grinding.
Be sure you’re using the rubber mat
under the container.
After the grinding mechanism is cleaned,
the upper burr will not lock into place.
There may still be some coffee particles
on lower burr; remove the upper burr
and clean again with the brush.
The error code “E2” appears in the display. The grinder has run continuously for
3 minutes or the motor is overheating;
unplug the unit, and wait 30 minutes for the
motor to cool down before using again.
9
Loading ...
Loading ...
Loading ...