Loading ...
Loading ...
Loading ...
4
9
E CLEAN START
Clean start function reduces the odor emitted by the heater at the ignition
significantly. It takes one or two more minutes to ignite than normal mode.
By pressing the clean start key M while the heater is off, the indication
is lit and
change to clean start mode.
Once the key is pressed again, the mode will turn off and return to the normal
ignition mode.
F IGNITING THE HEATER
When used for the first time, a new heater may give out a smell for a short while.
You should therefore provide extra ventilation.
Always ignite the heater with the
button
. Never use matches or a
cigarette lighter.
Just press the button to ignite the heater. The POWER lamp will start blinking,
indicating that the ignition procedure has started. This will take a short while.
Once the heater is burning, the POWER lamp will remain lit (red). The information
display will show two numbers. The light next to them indicates that these
numbers refer to the temperatures (Fig. G). The actual room temperature is
indicated below ROOM, while the temperature setting is indicated below SET. The
latter can be changed with the adjustment keys
(refer to Section G).
Prior to igniting the heater, always check for sufficient fuel in the removable tank.
G SETTING THE REQUIRED TEMPERATURE
Thetemperaturesettingcanonlybeadjusted,whentheheaterisburning.Use
the adjustment keys to adjust the temperature. First press either of the two
keys to switch on the function (the °C mark will start blinking). Next, adjust the
temperature using the key on the right (min.) to set the temperature to a higher
setting and the key on the left (hour) to lower the temperature. Press once to
increase the value one step. After approximately 10 seconds the °C mark will stop
blinking and the setting will be locked (Fig. G).
The available temperature settings range from 6°C minimum to 28°C maximum.
When the heater has been unplugged (or after a power failure), the temperature
will reset to the factory setting of 20°C.
H SWITCHING OFF THE HEATER
There are two ways to switch off the heater.
1
Press the
button . The information display will show the CLOCK
signal. Within approximately one minute the flame will have extinguished.
2
Press the TIMER key , when you want to switch off the heater and ignite it
again with the timer the next time. This not only switches off the heater, but
it also activates the timer function.
G: The required tempe-
rature on the left, the
measured temperature
on the right.
Loading ...
Loading ...
Loading ...