Ancona AN-1197 User Manual & Installation Instructions

Loading ...

— 13 —

Installation

STEP 8

Connect Ductwork

• Use 6 in. round steel pipe (follow building codes in your area) to connect the

exhaust on the hood to the ductwork above.

• Attach ductwork to damper. Secure the ductwork with duct tape to make

sure joints are secure and air- tight. Refer to Figure 4.

• Donotinstalltheducttapetootightlyasthismaypreventthedamperaps

from opening which will overwork the motor and cause improper functioning

of the unit.

• Fasten all connections with sheet metal screws and tape all joints with

certied aluminum or foil tape. Use caulking to seal exterior wall or roof

opening around the cap.

Fig #4

SAFETY WARNING: Risk of electrical shock. This range hood must be properly grounded. Make sure this

is done by qualied electrician in accordance with all applicable national and local electrical codes. Before

connecting wires, switch power off at service panel and lock service panel to prevent power from being switched

on accidentally.

STEP 9

Connect to AC

• Connect AC plug into a grounded AC outlet having 120 V,

60Hz.Placetheoutletatamaximumdistanceof33-1/2in.

(851 mm) from where the cord exits on the hood.

3-Pronged Plug

Ground Plug

3-Prong Receptacle

IMPORTANT:

• Observeallgoverningcodesandordinances.

• It is the customer’s responsibility to contact a qualified electrical installer.

• Ifcodespermitandaseparategroundwireisused,itisrecommendedthataqualifiedelectriciandeterminethat

thegroundpathisadequate.A120-Volt,60Hz,AC-only,fusedelectricalsupplyisrequiredonaseparate15-amp

circuit, fused on both sides of the line.

• DONOTgroundtoagaspipe.

• Checkwithaqualifiedelectricianifyouarenotsurethattherangehoodisproperlygrounded.

• DONOThaveafuseintheneutralorgroundcircuit.

IMPORTANT: Save this Installation Guide for electrical inspector’s use.

• Or cut off the plug and connect three wires (black, white and green) to house wires and cap with wire connectors.

Connect according to colors (i.e. black to black, white to white, and green to green). Store excess wires in the wiring

box.

• SEE IMPORTANT INSTRUCTIONS BELOW AND ON NEXT PAGE.

Loading ...

Ancona AN-1197 WPR636 Pyramid Range Hood