Loading ...
Loading ...
Loading ...
4. Hold the rear handle and let go of the front handle.
Let the product fall against the stump.
5. Make sure that the chain brake engages as the
guide bar hits the stump.
To do a check of the brake trigger
1. Put the product on stable ground and start it. See
Operation on page 14
.
WARNING: Make sure that the
saw chain does not touch the ground or
other objects.
2. Wrap your fingers and thumbs around the handles
and hold the product tight.
3. Apply full power and tilt your left wrist against the
front hand guard to engage the chain brake. The
saw chain must stop immediately.
WARNING: Do not let go of the front
handle!
To do a check of the power trigger lockout
1. Make sure that the power trigger and power trigger
lockout move freely and that the return spring
operates correctly.
2. Push the power trigger lockout forward (A) and
down (B). Hold the power trigger lockout against
the handle and make sure that it goes back to its
initial position when you release it.
A
B
3. Make sure that the power trigger is locked at the
idle position when the power trigger lockout is
released.
4. Start the product and apply full power.
5. Release the power trigger and make sure that the
saw chain stops and stays stationary.
WARNING: If the saw chain
rotates when the power trigger is in the
idle position, speak to your servicing
dealer.
To do a check of the chain catcher
1. Make sure that there is no damage on the chain
catcher.
2. Make sure that the chain catcher is stable and
attached to the body of the product.
26
1155 - 005 - 29.06.2020
Loading ...
Loading ...
Loading ...