Loading ...
Loading ...
Loading ...
AC Power Cord Connection
To connect the power cord to your
MM2000BT
simply plug female side of the power cord into the
power cord input which is on the rear of the
unit
. Then plug the male side of the power cord to an
electric outlet. The AC power cords supplied purposefully have 2 blades and one grounding prong. If
your outlet is not equipped to handle this type of plug, do not attempt to forcefully plug this AC power
cord into the outlet, and do not alter the plug so that it can fit in the outlet. The only course of action
you can take is to find another outlet which is properly equipped to handler a grounded plug or have
an electrician upgrade your electrical outlet. Be sure that the plug is well connected so that it does
not disconnect in the middle of usage. If at any point in time the supplied AC power cord is punctured
or damaged replace it with a new power cord from a local electrician.
NOTE: ONLY PLUG IN THE AC POWER CORD WHILE THE UNIT’S POWER IS OFF AND THE
VOLUME IS TURNED DOWN. TURNING ON THE UNIT WITH THE VOLUME TURNED UP MAY
CAUSE THE UNIT OR ANY SPEAKERS CONNECTED TO IT TO BE DAMAGED. ALWAYS TURN
DOWN THE VOLUME PRIOR TO TURNING OFF THE UNIT.
The MM2000BT is designed to power up to two groups of full-range passive loudspeakers. The speakers
should be connected via the speaker wire outputs on the rear of the MM2000BT.
Connecting the MM2000BT to Passive Loudspeakers
Input / Output Connections
Connecting the Signal Source to the MM2000BT(DVD/MIXER/MP3 etc.)
NOTE: BE SURE NOT TO CONNECT AN AMPLIFIER OR ANY AMPLIFIER SIGNAL INTO THE
RCA INPUT JACKS. AS THIS COULD DAMAGE THE MM2000BT. NO OTHER AMPLIFIER IS
NEEDED TO POWER YOUR SIGNAL IN ADDITION TO THE MM2000BT. ALWAYS MAKE SURE
THAT THERE IS ONLY ONE AMPLIFIER IN THE SIGNAL PATH.
There are also input jacks for USB flash drive and SD card on the front panel of the MM2000BT which
is compatible with iPod™(Classic and Nano) via the USB input. Just plug the USB flash driver, SD
card or iPod™(Classic and Nano) into their respective input jacks and set the MM2000BT to the
corresponding input. Be sure that the volume of the MM2000BT
are turned down at first and then
slowly raise the volume to prevent damage the speakers or any of your other equipment.
The
unit
has four RCA input jacks on the rear of the unit which is designed to receive the signal
directly from your CD, mixer or any of your other sources. To ensure that you have correctly connected
your CD player (other sound sources) to the unit, make sure that the CD player has a RCA cord
coming from its output and that this cord is plugging into the RCA Input on the rear of the MM2000BT.
NOTE: WHEN MAKING THESE CONNECTIONS THE POWER OF THE
MM2000BT
AND THE SIGNAL
SOURCE SHOULD ALL BE IN THE OFF POSITION WITH THE VOLUME LEVELS TURNED DOWN.
ONCE
THE UNITS ARE ALL POWERED ON, SLOWLY INCREASE THE VOLUME TO AVOID DAMAGING ANY
OF YOUR EQUIPMENT. THE
MM2000BT
OPERATE MOST EFFICIENTLY WHEN USED WITH 8 OHM
SPEAKERS.
Power Cord, User Manual, Warranty, FM Antenna, EQ Plug.
Accessories
MM2000BT
iPod™ & iPhone™ are registered trademarks of Apple Computers, Inc. Apple Computers, Inc. is not endorsing, sponsoring, or otherwise affiliated with this manufacturer.
Loading ...