Loading ...
Loading ...
Loading ...
Alarm
The watch beeps when a specified alarm time
is reached. You can configure up to two
standard daily alarms, and one daily alarm
with snooze. The hourly time signal causes the
watch to beep every hour on the hour.
●
Snooze causes the alarm to sound up to
seven times, at five-minute intervals.
●
If flash alert is enabled, display illumination
will flash along with the alarm beeper and
the hourly time signal.
l
Configuring Flash Alert Settings
Configuring Alarm Settings
There are various alarm variations, and the
variation that is set depends on the hour,
minute, month, and day settings you
configure.
●
Configuring Some of the Settings (hour,
minute, month, day)
ー
Hour and Minute Settings Only
The alarm sounds every day at the
specified time.
ー
Month, Hour and Minute Settings Only
The alarm sounds every day of the
specified month at the specified time.
ー
Day, Hour and Minute Settings Only
The alarm sounds every month at the
specified time on the specified day.
●
All Settings: Hour, Minute, Month, Day
The alarm sounds once at the specified time
on the specified date.
1. Enter the Alarm Mode.
l
Navigating Between Modes
2. Press (D) to scroll through alarms ([1], [2],
[SNZ]) until the one you want to configure
is displayed.
Alarm number
Alarm month, day
Alarm time
3. Hold down (A) for at least one second.
This causes the hours digits to flash.
Alarm hour
4. Use (C) to display the setting you want to
change.
●
Each press of (C) cycles through
settings in the sequence shown below.
Day
Month
Minutes
Hours
5. Use (B) and (D) to change the selected
setting.
●
Holding down (B) or (D) scrolls through
settings at high speed.
●
[-] is displayed for the month and [- -] is
displayed for the day if nothing is
specified for these settings.
●
If you are using 12-hour timekeeping,
[P] indicates a p.m. time when you are
setting the hour.
6. Repeat steps 4 and 5 to configure time
and date settings.
7. Press (A) to complete the setting
operation.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
●
Testing the alarm
In the Alarm Mode, hold down (D) to sound the
alarm.
●
To stop the alarm
To stop the alarm after it starts to sound when
an alarm time is reached, press any button.
Snooze causes the alarm to sound up to seven
times, at five-minute intervals. To cancel a
snooze alarm, turn [SNZ] off.
l
Turning Off an Alarm or the Hourly Time
Signal
Note
●
A beeper will sound for 10 seconds to
let you know when the alarm time is
reached.
●
The watch will automatically return to
the Timekeeping Mode from the Alarm
Mode after two or three minutes of non-
operation.
Watch Operation Guide 3522
9
Loading ...
Loading ...
Loading ...