Loading ...
Loading ...
Loading ...
Specifying Where You are
Using the Watch
Use the procedures below to specify a
longitude and lunitidal interval to specify the
location where you are using the watch to
check the Tide Graph and Moon age.
Note
●
The watch records the location you
specify here in memory. However, you
should re-configure this setting any
time you move to a different location
that is far from your current location.
●
Note that the initial factory default
location setting is shown below.
ー
Tokyo (UTC offset: +9, Longitude:
140°E)
ー
Lunitidal interval: 5 hours, 20
minutes
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least one second.
Release the button when the seconds
start to flash.
Seconds
3. Press (C) twice.
This causes the UTC offset digits to flash.
Time offset
4. Use (B) and (D) to change the Universal
Time UTC offset.
●
Holding down (B) or (D) scrolls through
settings at high speed.
●
The UTC offset can be set in 0.5-hour
units within a range of -12 to 0 to +14
hours.
5. Press (A).
This causes the longitude value to flash.
Longitude value
6. Use (C) to select the setting item you want
to change.
●
Each press of (C) cycles through setting
items in the sequence shown below.
Lunitidal interval (minutes)
Lunitidal interval (hours)
East longitude, west longitude
Longitude value
7. Configure the settings.
●
To configure the longitude setting
A
Use (B) and (D) to change the
value.
ー
Holding down (B) or (D) scrolls
through settings at high speed.
ー
You can specify a setting within
the range of 0° to 180° in 1° units.
For fractional values less than
1°, round off to the nearest whole
degree.
Example: For a longitude value
of 50°40’, input 51°.
ー
[LONG]
Indicates longitude (Longitude)
●
To specify east longitude or west
longitude
A Press (D) to toggle between [E]
(east longitude) and [W] (west
longitude).
●
To specify the lunitidal interval
A Use (B) and (D) to change the
value.
ー
Holding down (B) or (D) scrolls
through settings at high speed.
ー
Use information available on the
internet and from other sources
when specifying the lunitidal
interval.
ー
[INT]
Indicates the lunitidal interval
(Lunitidal Interval)
Lunitidal interval (hours)
Lunitidal interval (minutes)
8. Repeat steps 6 and 7 to configure the
longitude and lunitidal interval settings.
9. Press (A) to complete the setting
operation.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Watch Operation Guide 3522
12
Loading ...
Loading ...
Loading ...