Loading ...
Loading ...
Loading ...
16
Troubleshooting
234 1
2
3
4
1
REPLACEMENT
PARTS
To obtain replacement parts,
contact the local retailer
in your area or log onto
weber.com.
A
B
C
Using a Match to Determine if there is
Gas Flow to the Burners
1) Open the grill lid.
2) Check that all burner control knobs are in the
o
position. Check by pushing in and turning
knobs clockwise.
3) Turn the gas supply valve on.
4) Begin with burner 1 furthest to the left. Put
match in the matchstick holder and strike match.
(Matchstick holder is located under left side
table.) Insert lit match down through the cooking
grates, past the FLAVORIZER BARS and next to the
burner(A).
5) Push the burner control knob in and turn it
counterclockwise to the start/high
position.
6) Check that the burner is lit by looking through
the cooking grates and through the cutout in the
FLAVORIZER BARS.
7) If the burner does not ignite within 4 seconds,
turn burner control knob to the o
position and
wait five minutes to allow the gas to clear before
attempting to light the burner again. If repeated
attempts fail, follow the gas flow troubleshooting
instructions on the next page.
8) If the burner ignites, the problem lies in the ignition
system. Follow the instructions for “Checking the
Components of the Electronic Ignition System.”
9) After burner 1 ignites, you can turn on burner 2
(and burner 3).
10) Replace the matchstick holder by hanging
underneath left side table (B).
GRILL WILL NOT IGNITE
SYMPTOM
• Burner does not ignite when following the electronic ignition instructions in the “Operation” section of this Owner's Manual.
CAUSE SOLUTION
There is a problem with gas flow. If the grill will not ignite, the first step is to determine if there is gas flowing to the burners. Tocheck this,
follow the instructions below for “Using a Match to Determine if there is Gas Flow to the Burners.”
If match lighting IS NOT successful, follow the gas flow troubleshooting suggestions on the next page.
There is a problem with the electronic ignition system. If the grill will not ignite, the first step is to determine if there is gas flowing to the burners. Tocheck this,
followthe instructions below for “Using a Match to Determine if there is Gas Flow to the Burners.”
If match lighting IS successful, follow the instructions below for “Checking the Components of the Electronic
IgnitionSystem.”
Checking the Components of the
Electronic Ignition System
When pressing the ignition button you should hear a
ticking sound. If you cannot hear the ticking sound,
check the battery, then check the wires.
Checking the Battery
There are three potential issues with the battery that
supplies the power to your ignition module that need
to be checked:
1) Some batteries have a plastic protective wrap
around them. (Do not confuse this plastic with
the battery label.) Check that this plastic wrap is
removed.
2) Confirm that the battery is installed correctly (C).
3) If the battery is old, replace it with a new battery.
Checking the Wires
There are two potential trouble spots that need to be
checked:
1) Check that the ignition wires are connected
securely to the terminals on the ignition button
under the control panel.
2) Make sure the ignition wires are properly attached
to the ignition module. The wire terminals are color
coded to correspond with the terminals on the
ignition module. The number of wires will vary per
model.
Igniter Module Wire Chart
59504_Spt_II_NG_enUS_esMX_frCA_working.indd 16 8/24/17 2:33 PM
Loading ...
Loading ...
Loading ...