Loading ...
Loading ...
Loading ...
Programme default settings en
33
0 Programme default
settings
Programme default setti ngs
The default program settings are
displayed on the display panel once the
program has been selected.
You can change the default settings.
To do this, repeatedly press the
corresponding button until the required
setting value is displayed on the display
panel.
Note: Pressing and holding the button
will allow you to automatically scroll
through all the setting values to the last
value. Pressing it again will allow you to
change the setting values again.
You can find an overview of all possible
program settings on the supplementary
sheet for the installation and operating
instructions.
Spin speed
(0, rpm 0, Spin speed)
Depending on how far through the
program the appliance is, you can
change the spin speed (in rpm –
revolutions per minute) before and
during the program.
Setting 0: No final spin; the water is
simply pumped out. The laundry stays
wet inside the drum, e.g. for items that
are not to be spun.
- - - setting: Rinse Stop = no final spin;
the laundry stays in the water after the
final rinse.
You can select "Rinse Stop" to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the program has ended.
To resume/end the program
~ Page 38
The maximum speed that can be set
depends on the model and the program
that has been selected.
Ready in
(ñ, ñ Finished in, Finish in, Ready in)
Before starting the program, you can
preselect the program end time
("Ready in" time) in hourly increments
(h = hour), up to a maximum of
24 hours.
To do this:
1. Select a program.
The program duration will be
displayed for the selected program,
e.g. 2:30 (hours:minutes).
2. Press the Ready in button
repeatedly until the required number
of hours is displayed.
3. Press the A button.
The program will now start.
The selected number of hours (e.g. 8
h) is shown on the display panel and
counts down until the wash program
starts. The duration of the program
will then be displayed.
Note: The program duration is
automatically adjusted when the
program is running.
Certain factors can affect the program
duration, e.g.:
■ Program settings,
■ Detergent dosage (additional rinse
cycles may be required due to
foaming),
■ Load size/type of fabrics (water
absorption differs),
■ Imbalances (e.g. due to fitted
sheets) are eliminated by rotating
the drum briefly several times,
■ Fluctuations in power supply,
■ Water pressure (inflow rate).
Loading ...
Loading ...
Loading ...