Loading ...
Loading ...
Loading ...
SERVICE AND ADJUSTMENTS
•Adjust tie rod untildimension "A"is1/8" to 1/4" less than
dimension"B".
•Tighten jam nuts securely.
FRONT WHEEL CAMBER
The front wheel camber isnot adjustableon your tractor. If
damage has occurred to affect the front wheel camber,
contact your nearest authorizedservicecenter/department.
iFIG. 26
ADJUSTMENT SLEEVES
JAM NUTS
FIG. 27
TO REMOVE WHEEL FOR REPAIRS
(See Fig. 28)
•Block up axle securely.
•Remove axle cover, retainingringand washers toallow
wheel removal (rear wheel contains asquare key - Do
not lose).
•Repair tire and reassemble.
•On rearwheelsonly: align groovesinrearwheel huband.
axle. Insert square key.
•Replace washers and snap retaining ring securely in
axle groove.
•Replace axle cover.
NOTE: To seal tire punctures and prevent flat tires due to
slow leaks, tire sealant may be purchased from your local
parts dealer. Tire sealant also prevents tire dry rot and
corrosion.
WASHERS
.ETA,N,.Gk
AXLERING\/\ |lr/(( Ikll
FIG. 28
TO START ENGINE WITH A WEAK BATTERY
(See Fig. 29)
CAUTION: Lead-acid batteries generate
explosive gases. Keep sparks, flame
and smoking materials away from bat-
teries. Always wear eye protection when
around batteries.
If your battery is too weak to start the engine, it should be
recharged. If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12
VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER
VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE
GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR
BATTERY TO START OTHER VEHICLES.
TO A'I-I'ACH JUMPER CABLES -
•Connect each endofthe RED cable tothe POSITIVE (+)
terminal ofeach battery,takingcare notto short againfit
chassis.
•Connectone endofthe BLACKcableto the NEGATIVE
(-) terminal offullycharged battery.
•Connect the other end of the BLACK cable to good
CHASSIS GROUND, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
•BLACK cable firstfrom chassis and then from the fully
charged battery.
•RED cable lastfrom both batteries.
TERMINAL NEGATIVE TERMINAL
POSITIVE TERMI CHARGED
BATTERY
FIG. 29
REPLACING BA'I-rERY (See Fig. 30 and 31)
CAUTION: Do not short battery termi-
nals by allowing a wrench or any other
object to contact both terminals at the
same time, Before connecting battery,
remove metal bracelets, wristwatch
bands, rings, etc.
Positive terminal must be connected
first to prevent sparking from accidental
grounding.
22
Loading ...
Loading ...
Loading ...