Loading ...
Loading ...
Loading ...
PCH796DR&PCH990R&PCH960R
A: Touch A , the fan runs at the low speed. Press it again, the fan turns off.
B: Touch B, the fan runs at the mid speed. Press it again, the fan turns off.
C: Touch C, the fan runs at the high speed. Press it again, the fan turns off.
A、B、C three bottons interact.
D: When the hood stay OFF, keep touching D 3s, and then touch C and E to adjust hour
and minute, at that time, G just like a clock.
When the hood is operating , touch D to control working time of hood, 5 minutes per
one touch, the longest stay ON time is 60 minutes.
E: Touch E, torn on the light. Press it again, turn off the light.
F: When the hood is operating , touch F, the hood will not be OFF at once, it will stay
one minute, and then be OFF.
PCH794DR
This switch is highly-sensitive touch control, use your figure touch the key-press slightly to operate it.
And this switch with gas sensor and heater sensor function.
F
A
B
E
D
G
A. Motor on/off: Touch one time when the hood in working, it will
continue working one minute, touch again two times it will turn off.
B. Lighting: Touch this button, the light will be lighted, touch
again the light will be extinguish.
C. Receiver: Direct the remote control at the receiver when use.
D. High speed: Touch this speed, the motor will work in high speed.
E. middle speed: Touch this speed, the motor will work in middle speed.
F. Low speed: Touch this speed, the motor will work in low speed.
,
G. Timer: touch this button one time when it s in working condition,
it will turn off in one minute. Touch one more time, one more minute
working time increased.
change of electron
1.Open the electron cover,refer to pic 1.
2.When open,pls pay attention to the anode and cathode,refer to pic 2.
3.Take out the old electro and fix the new one and make sure the anode is as pic 3.
ABCDEF
10
6
Cubierta del ducto interno
Cubierta del ducto externo
Ranura de
orientación
Cubierta del ducto interno
Cubierta del ducto externo
Tornillos de fijaci n
para el ducto externo
ó
Paso 3:
Ponga el ducto interno en el ducto externo.
Tenga en cuenta que el ducto interno debe
fijarse de acuerdo a la ranura de orientación.
Paso4:
Ponga el ducto externo en la carcasa de la
unidad. Use dos tornillos M4x10 para fijar el
ducto exterior a la unidad.
3
2
165
229
250
40
Tubo de expansi nó
5x60
Tubo de expansi nó
Soporte
1
4
Paso 2
Perfore agujeros en la pared usando un perforador
de 8mm de diámetro. Use tres tornillos para fijar la
campana en la pared en los agujeros 1, 2, 3. Luego
use un tornillo M4X10 para fijar la campana en el
agujero 4, de manera de estar seguro de que no se
va a mover.
5x60
Soporte
A B
C
D
306
310
Tubo de expansi nó
Tubo de expansi nó
10mm
350-400mm
Paso 1:
Por favor ponga la campana en la pared y marque
la posición en la que la desea instalar.
Recomendamos que la altura desde la estufa
hasta la parte inferior de la campana debe ser
entre 350 mm hasta 400 mm.
INSTALACION PARA MODELOS PCH990R&PCH960R
Loading ...
Loading ...
Loading ...