Loading ...
Loading ...
Loading ...
46
3. Sanitizing Solution
Dilute 2.5 ๎. oz. (74 ml or 5 tbs) of a 5.25% sodium hypochlorite solution (chlorine
bleach) with 5 gal. (19 l) of warm water. This is a minimum amount. Make more solution
if necessary. IMPORTANT! For safety and maximum effectiveness, use the solution
immediately after dilution.
4. Sanitizing Procedure - Initial
1) Make sure the power supply is off and the icemaker water supply line shut-off valve
is closed. Remove the front and top panels, then move the power switch to the "OFF"
position.
2) Remove the spout spring, then open the spout cover. See Fig. 22. Next, remove the
proximity switch from the spout assembly, then remove the spout and chute assembly,
and spout packing from the icemaker.
3) Pour the sanitizing solution over the extruding head until the evaporator assembly and
the reservoir are full and the solution starts to run through the over๎ow hose on the
reservoir.
4) Remove the spout and chute insulation straps, then remove the spout and chute
insulation and set aside.
5) Soak the spout assembly, chute, and spout packing in the sanitizing solution for 10
minutes then wipe them down. Next, wipe down the chute packing at the base of the
icemaker.
6) Rinse the parts thoroughly with clean water.
7) Replace the spout packing, chute, spout assembly, insulation, and insulation straps in
their correct positions. Next, open the spout cover and replace the proximity switch in its
correct position, then close the spout cover and replace the spout spring in its correct
position. IMPORTANT! Be sure the insulation is placed back in its correct position
and secured with the insulation straps.
8) Move the control switch to the "ICE" position, then move the power switch to the "ON"
position. Replace the panels in their correct positions, then turn on the power supply.
Make ice using the solution until the icemaker stops making ice.
9) Turn off the power supply, then remove the front panel. Move the control switch to the
"DRAIN" position, then replace the front panel in its correct position.
10) Turn on the power supply and allow the water system to drain completely.
11) Turn off the power supply.
Loading ...
Loading ...
Loading ...