Loading ...
Loading ...
Loading ...
en Installation instructions
24
¡ Only a licensed professional may connect
appliances without plugs. Damage caused
by incorrect connection is not covered un-
der the warranty.
WARNING‒Risk of injury!
Parts that are accessible during installation
may have sharp edges and may lead to cut-
ting injuries.
▶ Wear protective gloves
WARNING‒Risk of fire!
It is dangerous to use an extended power
cord and non-approved adapters.
▶ Do not use extension cables or multiple
socket strips.
17.2 Appliance dimensions
You will find the dimensions of the appliance here
17.3 Fitted units
This appliance is only intended to be fully fitted in a kit-
chen. It is not intended to be used as a tabletop appli-
ance or within a cupboard.
The fitted cabinet must not have a back panel behind
the appliance. Maintain a clearance of at least 35mm
between the wall and the cabinet base or the rear
panel of the cabinet situated above.
The fitted cabinet must have a ventilation opening of
50cm² on the front. To do this, trim the base panel or
fit a ventilation grille.
Surround units without a ventilation cut-out must have a
ventilation opening measuring 200cm² towards the
rear of the side panels.
Ventilation slots and intake openings must not be
covered.
The mains socket for the appliance must either be loc-
ated in the hatched area or outside of the area
where the appliance is installed.
Any unsecured units must be secured to the wall using
a standard bracket .
17.4 Electrical connection
In order to safely connect the appliance to the elec-
trical system, follow these instructions.
WARNING‒Danger: Magnetism!
The appliance contains permanent magnets. These
may affect electronic implants, e.g. heart pacemakers
or insulin pumps.
▶ Persons with electronic implants must stay at least
10cm away from the appliance.
¡ The appliance corresponds to protection class I and
must only be operated with a protective earth con-
nection.
¡ The fuse protection must correspond to the power
rating specified on the appliance's rating plate and
to local regulations.
¡ The appliance must be disconnected from the
power supply whenever installation work is being
carried out.
¡ If the plug is no longer accessible following installa-
tion, an all-pole isolating switch with a contact dis-
tance of at least 3mm must be present.
¡ The appliance must only be connected to a protect-
ive contact socket that has been correctly installed.
¡ Contact protection must be guaranteed by the in-
stallation.
Loading ...
Loading ...
Loading ...