Kenmore 79060720902 gas range

User Manual - Page 14

For 79060720902.

PDF File Manual, 16 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Before You Call
Before you carl for service, review this list. It may save you time and expense. The list includes common occurrences that
are not the result of defective workmanship or materials in this appliance.
OCCURRENCE
Range is not level.
Cannot move appliance easily. Appliance
must be accessible for service.
POSSIBLE CAUSE/SOLUTION
Poor installation. Place oven rack in center of oven. Place a level on the oven rack.
Adjust leveling legs at base of range until the rack is level. When range is level,
cooktop may appear out of alignment if countertop is not level.
Weak, unstable floor. Be sure floor is level and can adequately support range.
Contact a carpenter to correct sagging or sloping floor.
Kitchen cabinet misalignment may make range appear to be unlevel. Be sure
cabinets are square and have sufficient room for range clearance.
Cabinets not square or are built in too tight. Contact a cabinet maker to correct the
problem.
Contact builder or installer to make appliance accessible.
Carpeting interferes with range. Provide sufficient space so range can be lifted over
carpet.
Gas line is hard-plumbed. Have a flexible A.G.A./C.G.A. approved metal appliance
connector installed.
Surface burners do not light. Surface control knob has not been completely turned to LITE. Push in and turn the
Surface control knob to LITE until burner ignites and then turn control knob to
desired flame size.
Surface bumerflame burns halfway around.
Surface burner flame is orange.
Burner ports are clogged. With the burner off, use a small-gauge wire or needle to
clean ports. See "Surface Burners" in the cleaning chart under Care & Cleaning for
additional cleaning instructions.
Range power cord is disconnected from outlet (electric ignition models). Be sure
cord is securely plugged into the outlet. Pilot ignition models - is pilot lit.
Electrical power outage (electric ignition models). Burners can be lit manually. See
Setting Surface Controls.
Burner ports are clogged. With the burner off, clean ports by using a small-gauge
wire or needle.
Moisture is present after cleaning. Lightly fan the flame and allow burner to operate
until flame is full. Dry the burners thoroughly following instructions in the Care &
Cleaning section.
Dust particles in main line. Allow the burner to operate a few minutes until flame
turns blue.
Oven does not operate.
Entire appliance does not operate.
In coastal areas, a slightly orange flame is unavoidable due to salt air.
Be sure the oven controls are set correctly for the desired function. See Setting
Oven Controls or Entire Appliance Does Not Operate (see below).
Be sure regulator gas valve is "ON". See installation instructions.
Make sure electrical cord/plug is plugged tightly into outlet (electric ignition models).
Service wiring not complete. Contact your authorized Sears Service Center for
assistance.
Electrical power outage (electric ignition models). Check house lights to be sure.
Call your local electric company for service. Surface burners can be lit manually.
See Setting Surface Controls.
Be sure gas supply is turned on.
14
Loading ...
Loading ...