Loading ...
Loading ...
Loading ...
Installation Instructions
EXHAUSTING HOT AIR
In the COOLING Mode the appliance must be placed close to a window or
opening so that the warm exhaust air can be ducted outside.
First position unit on a flat floor and make sure there's a minimum of 30.5cm
clearance around the unit, and is within the vicinity of a single circuit outlet
power source.
1. Take the hose out from back of the unit (Fig. 3).
2. Remove adaptor A from unit by sliding sideways (Fig. 4 ).
3. Extend either side of the hose (Fig. 5) and screw the hose to
adaptor A (Fig. 6).
4. Extend the other side of the hose and screw it to adaptor B (Fig. 7).
5. Slide the assembly onto unit (Fig. 8).
6. Affix the adaptor B into the window slider kit and seal. (Fig. 9&10)
Vertical
window
I -4- o
VindowSliderKit
linimum:67.5cm(26.6")
laxmum: 123cm(48.5")
J
Fig. 9
Horizontal
window
Window Slider Kit
Minimum :67,5cm(26,6")
Haxmum: 123cm(48.5")
Fig, 10
Takethe hoseout
1
Fig. 3
g, 4
Extend the side of hose
Fig, 5
Fig, 6
The hose can be extended from its original length of 38.1cm up to 139.7cm,
but it is the best to keep the length to minimum required. Also make sure
that the hose does not have any sharp bends or sags. (Fig. 11)
Fig, 7
////
////
////
/z/z
Ill.
2"/%
Y/%
////
y/%
////
///z
Fig. 11
0
@2009 Electrolux HomeProducts, Inc. All rights reserved, u_'
3
Loading ...
Loading ...
Loading ...