Loading ...
Loading ...
Loading ...
LED WORKLIGHT (Fig. 5)
The LED worklight, located on
the base of the impact driver,
will illuminate when the trigger
switch is depressed. This provides
additional light on the surface of
the workpiece. The LED worklight
will turn off when the trigger
switch is released.
BIT STORAGE (Fig. 6)
When not in use, the bit can be
placed in the storage area located
on the base of the impact driver.
Store the bit on the base of the
driver by snapping it into place in
the bit clip.
INSTALLING BITS (Fig. 7)
1. Remove the battery pack
from the impact driver when
installing the bit.
2. Lock the trigger switch on the
impact driver by placing the
direction-of-rotation (forward/
center-lock/reverse) selector
in the center position.
3. Pull the coupler away from
the driver.
4. Insert the driver bit into
the coupler.
5. Release the coupler.
6. Pull on the bit to make sure
it is secured in the coupler.
There may be some play in
the installed bit; this is normal.
Fig.
LED Worklight
Fig. 6 ____
Bit Clip
Fig. 7
Release
Pull
i
,_ WARNING: Make sure the bit is secured in the coupler before using the
impact driver. If the coupler does not return to its original position, the bit is not
correctly installed. Retry until the bit is properly installed and the coupler returns
to its original position. Failure to do so could result in serious personal injury.
13
Loading ...
Loading ...
Loading ...