Loading ...
Loading ...
Aug17, 2009 11'10AM W&ter!00 Gr_nd
i i= i
No,1181 P. 3
I.r WARNING: !
DO NOT ALTER THE PRODUCT IN THE FOLLOWING MANNER:
1) WELDING LOCK BARS OR DOLLIES ONTO THE UNIT.
2) MOUNTING CHEST OR ROLLAWAY ONTO ANY MOVING OBJECT SUCH AS TRUCK
BED, BOAT DECK, OR CAR TRAILER.
j! WARNING: J
STORAGE UNIT WILL TiP IF A NUMBER OF DRAWERS ARE EXTENDED WHICH MAY
CAUSE PERSONAL INJURY OR DAMAGE.
IF WARNING: I
BEFORE MOVING UNIT, BE SURE ALL DRAWERS ARE FULLY CLOSED AND LOCKED.
FAILURE TO DO SO MAY CAUSE PERSONAL INJURY OR DAMAGE.
HELPFUL HINTS:
1) Periodically drawer front, pulis and other rollaway and chest surfaces should be
cleaned with a milcl detergent end water to keep them looking new.
2) Chest may be attached to the rollaway after the rollaway is assembled with the four
3/8-16 x 3/4" screws (D). Remove the top two drawers of the rollaway and screw
.3/8-16 x 3/4" screws (D) into weldnuts in chest and wrench tighten.
3) For ease of operation, lubricate slide channels periodically with petroJeum jelly,
4) If:it becomes necessary to remove drawers for cleaning or due to damage follow these
slide removal instructions.
COMPOUND SLIDES:
A. Pull drawer all the way open then push back 1/16 of an inch.
B. Insert a screwdriver into this slot in the slide and push in on the stop un'til it clears the
lance, Repeat the procedure on the other slide and remove drawer.
C. To reinstall drawer, pry stop far enough out to engage lance(3/1 6" to 1/4") and push
drawer onto slides until stops engage lances.
BALL BEARING SLIDES:
A. Pull drawers all the way open.
B. Remove screw and washer from both sides of drawer.
C• Lift drawer up and out until tabs in slide clear slots in drawer.
D. To reinstall, reverse procedure,
_ IDE
COMPOUND SLIDE
STO
SCREWDR I_
LUBRI CATE zj'_
2
m i i in i _
Loading ...
Loading ...
Loading ...