Loading ...
Tub and Door Seal
The door seal is pressed into the tub channel for
an interference fit. Center the gasket (marked on
back) at the tub top center and press in place
Product Specifications
Electrical
Rating .................................. 120 Volts, 60Hz
Separate Circuit..15 amp min.- 20 amp
max.
Motor (Amps) ........................................... 1.1
Heater Wattage ....................................... 900
Total Amps (load rated) ......................... 10.0
Temp Boost Wash ....................... 117°F±5°F
(47°C±3°C) [with outer door in place]
Temp Boost Rinse ................... 122°F (50°C)
Hi-Limit Thermostat ................ 200°F (93°C)
Water Supply
Suggested minimum incoming water
temperature ............................. 120°F (49°C)
Pressure (PSI) min./max. ................... 20/120
Connection (NPT) .....................................
3
/
8
"
Consumption (Normal Cycle) .......................
......... 6.0 U.S. gal., 5.0 Imp. gal., 22.7 liters
Water valve flow rate (U.S. GPM) .......... .83
Water recirculation rate (U.S. GPM)..............
.................................................... approx. 12
Water fill time ..................................... 87 sec.
Detergent and Rinse Aid Dispenser
The detergent and rinse aid dispenser is a one
piece component consisting of a molded
detergent cup and a built-in rinse aid dispenser.
The detergent cup has a spring loaded cover
and the rinse aid dispenser has a removable
cover.
Liquid rinse aid is added to the dispenser up to
the fill line indicator. The amount of rinse aid
released can be adjusted by turning the arrow
indicator from one, being the least amount, to
four, being the greatest amount.
To replace dispenser:
• shut off electricity to dishwasher,
• remove outer door panel assembly,
• disconnect wiring to the actuator,
• remove the six screws,
• remove the dispenser,
• replace and reinstall screws,
• rewire actuator.
Symptom
turned on (wait at least 90 seconds).
overload protector.
open.
Timer does not advance.
without stretching or bunching. The gasket takes
a short turn at the bottom of the tub channel
before ending at the channel end wall.
Tub
Interior
Mounting
Rib
Gasket Cross Section
Short Turn
Standard Dry Air Flow
The heated, moist air leaves the dishwasher
through the console vent causing drier air to be
drawn into the unit by way of intake vents located
at the bottom of the door. The water on the
dishes is evaporated into drier air and the venting
process continues. The heating element is turned
ON and OFF during the entire drying cycle.
Loading ...
Loading ...
Loading ...