Loading ...
Loading ...
Loading ...
Washers A
Retaining '_ ff__lJ
R'ng-_-_'____] I
AxleCover "_Square ey
(Rear Wheel Only)
TO START ENGINE THAT HAS A WEAK
BATTERY
ACAUTION: Lead-acid batteries gener-
ate explosive gases. Keep sparks, flame
and smoking materials away from batter-
ies. Always wear eye protection when
around batteries.
If your battery is too weak to start the
engine, it should be recharged. (See
"BATTERY" in the MAINTENANCE sec-
tion of this manual). _
If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT: Your tractor Is equiped with
a 12 volt negative grounded system. The
other vehical must also be a 12 volt nega-
tive grounded system. Do not use your
tractor battery to start other vehicals.
TO ATTACH JUMPER CABLES -
• Connect each end of the RED cable to
the POSITIVE (+) terminal of each bat-
tery, taking care not to short against
chassis.
• Connect one end of the BLACK cable to
the NEGATIVE (-) terminal of fully
charged battery.
, Connect the other end of the BLACK
cable to good CHASSIS GROUND,
away from fuel tank and battery.
I'O REMOVE CABLES, REVERSE
_)RDER -
• BLACK cable first from chassis and
then from the fully charged battery.
0 RED cable last from both batteries.
- ._ -. - .:=.
..H._lt_Panel
IEPLACING BATTERY
LCAUTION: Do not short battery termi-
als by allowing a wrench or any other
bject to contact beth terminals at the
ame time. Before connecting battery,
•_move-mlJlEfl:)rac_lbts, wristwatch
ands,rings,etc.
Positive terminal must be connected first
to prevent sparking from accidental
grounding.
• Lift hood to raised position.
• Remove terminal guard.
• Disconnect BLACK battery cable then
RED battery cable and carefully remove
battery from tractor.
• Install new battery with terminals in
same position as old battery.
• Reinstall terminal guard.
• First connect RED battery cable to posi-
tive (+) battery terminal with hex bolt
and keps nut as shown. Tighten secure-
l.ly
• (_onnectBLACK groundingcableto
negative(-)batteryterminalwith
remaininghex boltand keps nut.
Tightensecurely
• Close terminal access doors.
• Close hood.
Terminal keps Nut
Access
Door
: Hex Bolt
•,- Positive
• Cable
Terminal
Guard
(Black) Cable
TO REP!.ACE HEADLIGHT BULB
• Raise hood.
• Pull bulb holder out of the hole in the
backside of the grill.
• Replace bulb in holder and push bulb
holder securely back into the hole in the
backside of the grill.
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may. cause your
tractorto run poorly, stop running, or pre-
vent it from starting.- "
• Check widng. See electrical widng dia-
gram in the Repair Parts section of this
manual.
TO REPLACE FUSE
Replace with 30 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
TO REMOVE HOOD AND GRILL
ASSEMBLY
• Raise hood.
• Unsnap headlight wire connector.
• Stand Jnfront of tractor. Grasp hood at
sides, tilttoward engine and lift off of
tractor.
• To replace, reverse above procedure.
28
Loading ...
Loading ...
Loading ...