Loading ...
Loading ...
Loading ...
outdoor Unit
Installation
Page 30
Before installing a wall-mounted unit,make sure that the wall is made of
solid brick, concrete,or a similarly strong material. The wall must be able
to support at least 4 times the weight of the unit.
1.Mark the position of the bracket holes based on the dimensions in the Mounting Dimensions
chart on the previous page.
2.Pro-drill the holes for the expansion bolts.
3.Clean dust and debris away from the holes.
4.Place a washer and nut on the end of each expansion bolt.
5.Thread expansion bolts through the holes in the mounting brackets.Then,put the mounting
brackets in position and hammer the expansion bolts into the wall.
6. Check that the mounting brackets are level.
7.If the feet of the outdoor unit have rubber pads already installed , and you are using a local
dealer s wall-mounting bracket,remove them before attempting to mount the condenser to
the bracket.The mounting bracket has rubber isolating pads on it that will take the place of
these.
8.Carefully lift the unit and place its mounting feet on the brackets.
9.Then,bolt the unit rmly to the brackets.
,
If you are installing the outdoor unit on the ground,or a concrete mounting
platform,use the following steps:
1.Mark the positions for four expansion bolts based on dimensions in the Mounting Dimensions
chart and illustrations above.
2.Pre-drill holes for expansion bolts.
3.Clean concrete dust away from the holes.
4.Place a nut on the end of each expansion bolt.
5.Hammer expansion bolts into the pre-drilled holes.
6.Remove the nuts from the expansion bolts,and place outdoor unit on bolts.
7.Put a washer on each of the expansion bolts,then reinstall the nuts.
8.Using a wrench,tighten each nut until snug.
WHEN DRILLING INTO CONCRETE,EYEPROTECTION
IS RECOMMENDED AT ALL TIMES.
Loading ...
Loading ...
Loading ...