Loading ...
Loading ...
Loading ...
34
Delay start selection
This button allows you to programme the
start of the wash cycle, with a delay
between 0:30 and 24 hours.
To set the delayed start proceed as follows.
1. Switch the dishwasher on by holding
down the "ON/OFF"
button for about
3 sec.
2. Select the washing programme.
3. Press the "DELAY START"
button
("0:30" will appear on the display).
4. Press the button again to increase the
delay (each time it is pressed, the delay
is increased by 30 minutes, up to a
delay of 4 hours. Each time the button
is pressed it will increase by 1 hour up
to a maximum of 24:00. Pressing the
button again after a delay of 24:00 will
return to 0:00 (delayed start disabled).
5. The delayed start settings will remain
visible on the display for 5 seconds, or
until the ON/OFF - PROGRAMME
SELECTION – START/RESET buttons
are pressed
Countdown and starting a programme
with DELAY START
When the delay is set on a programme:
- Press "START/RESET"
the "DELAY START" light stays on until
the end of the time.
the countdown of the delay time starts
showing on the display "START IN XX:
XX".
The time will be displayed with an interval
of every 30 minutes in the 24 hours, and
in the last 2 hours the interval will be
displayed every minute.
if you press any button (except the "ON /
OFF, Wi-Fi Enrollment, START/
RESET" buttons for 3 seconds, the
programme name "P XX NAME" is
displayed (P + programme number +
programme name) for one single scroll
and then the delay time is displayed
again.
If you want to cancel the delayed start
proceed as follows:
Press and hold the "START/RESET"
button for at least 3 seconds. The display
will show "RESET" and beeps will sound.
The delayed start and the selected
programme will be cancelled. The name
of the programme will appear on the
display.
At this point, if you want to start the
dishwasher, you will need to set the
desired programme again and select the
option buttons, if necessary.
In the event of a power failure or
shutdown, the dishwasher stores the
time remaining before starting, which
will be resumed at the point where it
was interrupted as soon as the power
supply is restored or the machine is
switched on again.
When you press the DELAY START
"button, the last setting made will be
displayed.
Changing the programme does not
change the delay time and the LED will
remain on.
DELAY START button
If the SALT and RINSE AID level is set
to 0, this will never happen.
Loading ...
Loading ...
Loading ...