Loading ...
Loading ...
Loading ...
WWW.SENIXTOOLS.COM 17 - EN
To remove:
Press the unlock button on the battery pack and slide out
the battery pack.
OPERATION
WARNING:
To avoid serious personal injury, do not operate
the chainsaw without the guide bar, saw chain
and side cover properly assembled.Do not
attempt to operate the chainsaw if any part is
damaged or missing.
TESTING THE CHAIN BRAKE
This chainsaw is designed with a function of chain brake
on the guard, which stops both the motor and the motion of
the chain when kickback occurs. The chain brake can be
activated by pushing the guard forward as the saw rotates
backward during kickback. Make sure the chain brake can
work normally without any malfunctions before using the
chainsaw.
To check the chain brake (Fig.7):
• Place the saw on a firm, flat surface.
• Start the saw briefly.
• Push the guard forward to activate the function of chain
brake. A properly functioning chain brake stops the motor
and saw chain immediately. If the motor and saw chain do
not stop immediately, have the chain brake checked at an
approved service location.
• Release the switch trigger.
• Return to operating position.
PRIMING THE OILER
WARNING:
Keep hands, clothing, and hair away from the
drive sprocket when priming the oiler.
NOTE:
Prime the oiler before the first use or after being stored for
a long time.
It is essential to fill with oil before use. Operating the
chainsaw without bar and chain oil will result in damage to
the chain saw. The chain is automatically lubricated with oil
during operation via the oil outlet.
1. Insert the battery.
2. Run the chainsaw for about two minutes.
3. Remove the battery.
4. Remove the side cover.
5. Check for oil on the bar.
TENSIONING THE SAW CHAIN
NOTE:
Check the tension between the saw chain and the guide bar
before every start.
WARNING:
Only tension the saw chain when the chain is
cool. A hot chain may contract and damage the
guide bar or chain as it cools.
1. It is no need to remove the side cover for adjusting
tension of saw chain. Just loosen the side cover nut
slightly to unlock the guide bar and saw chain which
completely locked during operation.
2. Twist the tensioning knob till the chain come to a suitable
tension status. The saw chain is correctly tensioned
when it can be raised approx. 2–3 mm from the chain
bar in the centre.
3. Finally tighten the side cover nut after adjustment.
NOTE:
If the chain is still loose when the saw is at maximum
tension, replace the chain.
SWITCHING ON/OFF
Ensure the guard is at operation position. If not, turn it back
manually.
Keep pressing the trigger lock-out at first, then squeeze the
switch trigger to start the product. Just release the trigger
lock-out once the chainsaw starts (Fig.8).
To turn off the chainsaw, release the switch trigger .
OVERHEAT PROTECTION OF
CHAINSAW
When the temperature of PCB is above 248°F(120°C)
during operation, The chainsaw will be shut down
DXWRPDWLFDOO\:DLWLWWRFRROGRZQIRUDERXW¿YHPLQXWHV
then restart the product.
Loading ...
Loading ...
Loading ...