Loading ...
Loading ...
Loading ...
LOCATION
• Two people should be used when moving the
appliance. Place the appliance on a fl oor that
is strong enough to support it when it is fully
loaded.
• Remove interior and exterior packaging prior to
installation. Wipe the outside of the appliance
with a soft, dry cloth and the inside with a
lukewarm wet cloth.
• Do not place the appliance in direct sunlight or
near sources of heat, such as a stove or heater,
as this can increase electrical consumption.
Extreme cold ambient temperatures may also
cause the appliance to perform improperly.
• Do not use the appliance near water, for
example, in a wet basement or near a sink.
• This appliance is intended for indoor household
and garage use only. Freezers are tested to
perform in temperatures ranging from -17 -
43°C (0 - 110°F). It is not designed for outside
installation, including anywhere that is not
temperature controlled.
• Before connecting the appliance to a power
source, let it stand upright for approximately
6 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
• This appliance is 82.7 cm (32.6 inches) wide by
84.6 cm (33.3 inches) high by 55.6 cm (21.9
inches) deep.
• Allow 12.7 cm (5 inches) of space between the
back and sides of the appliance and all adjacent
walls for proper air ventilation.
• This appliance is intended for free-standing
installation only and is not intended to be
built into a cabinet or counter. Building in this
appliance can cause it to malfunction.
FEATURES
1. Rust Resistant Interior
2. Wire Baskets
3. Thermostat Dial
4. Drain and pan
5. Leveling Legs
3
INSTALLATION INSTRUCTIONS OPERATING INSTRUCTIONS
1
2
3
4
5
CONTROL PANEL
1. Power indicator light: Illuminates when the
appliance is connected to a working power
source.
2. Freezer indicator light: Illuminates when the
appliance is set to run as a freezer.
1 2
LEVELING INSTRUCTIONS
There are two adjustable legs on the bottom of the
appliance that can be turned up or down to ensure
that the appliance is level. It is important that the
appliance is level to minimize noise and vibration.
Move the appliance to its fi nal location. Turn the
leveling leg counter-clockwise as far as it will go,
until the top of the foot is touching the bottom of the
cabinet. Slowly turn the leveling leg clockwise until
the appliance is level.
Loading ...
Loading ...
Loading ...