Loading ...
Loading ...
Loading ...
SERVICE
BEFORE CALLING A SERVICE TECHNICIAN, CHECK THE FOLLOWING:
1. Burner flame uneven.
2. Burner fails to light.
3. Oven temperature inaccurate.
• food takes too long or cooks to
fast.
• pale browning.
• food over-done on outside and
under-done in center.
• over browning.
4. Clock and/or light do not work.
5. Surface burner flame
• liftsoff port
• yellow in color
F plus a number appears in the dis-
play and a continuous beep sounds.
(Example: F 1)
Control will not accept an entry.
a. clogged burner port(s), a. clean ports with straight pin. Be
sure ignitors are not sparking.
a. power supply not connected.
b. controller incorrectly set.
a. oven not preheated.
b. incorrect rack position.
c. incorrect use of foil.
d. oven bottom incorrectly re-
placed.
e. oven thermostat sensing device
out of holding clip(s).
a. power supply not connected.
b. burned out light bulb.
c. malfunctioning switch.
d. malfunctioning clock or Ioosewir-
ing.
a. air/gas mixture not proper
a. connect power, check circuit
breaker or fuse box. Oven wilt not
operate during a power failure.
b. see page 4.
a. preheat oven 10 minutes.
b. see page 10.
c. see page 10.
d. replace oven bottom correctly.
e. reinsert sensing device securely
into clip(s).
a. connect power supply, check cir-
cuit breaker or fuse box.
b. replace light bulb.
c. call serviceman to check.
d. call serviceman to check.
a. call serviceman to adjust burner
primary air
This is called a FAULT CODE. If a fault code appears in the display, press the
STOP/CLEAR pad. if the fault code reappears, disconnect power to the unit and
call the servicer.
This may indicate a "stuck" pad. Press each of the seven pads to disengage the
pad. Then, press STOP/CLEAR pad and reprogram the operation. If the control
still does not accept an entry after checking each pad, call the servicer.
SERVICE
Do not attempt to service the appli-
ance yourself unless directed to do
so in this book. Contact the dealer
who sold you the appliance for serv-
ice.
HOW TO OBTAIN
SERVICE
When your appliance requires service
or replacement parts, contact your
Dealer or Authorized Servicer. Use only
genuine factory or Maycor parts if re-
placement parts are necessary. Consult
the Yellow Pages in your telephone di-
rectory under appliance for the service
center nearest you. Be sure to include
your name, address, and phone num-
ber, along with the model and serial
numbers of the appliance. (See front
cover for location of your model and se-
rial numbers.)
If you are unable to obtain service, write
to us. Our address isfound onthe rating
plate. See front cover for location of rat-
ing plate.
If you are not satisfied with the local re-
sponse to your service requirements,
call or write MAYCOR Appliance Parts
and Service Company, 240 Edwards
Street, S.E., Cleveland, TN 37311,
(615) 472-3500. Include or have avail-
able the complete model and serial
numbers of the appliance, the name and
address of the dealer from whom you
purchased the appliance, the date of
purchase and details concerning your
problem.
-16-
If you did not receive satisfactory serv-
icethrough your servicer or Maycor you
may contact the Major Appliance Con-
sumer Action Panel by letter including
your name, address, and telephone
number, as well as the model and serial
numbers of the appliance.
Major Appliance Consumer Action Panel
20 North Wacker Drive
Chicago, IL 60606
MACAP (Major Appliance Consumer
Action Panel) is an independent agency
sponsored by three trade associations
as a court of appeals on consumer com-
plaints which have not been resolved
satisfactorily within a reasonable period
of time.
Loading ...