Summit FF27BSSADA 27" Wide Built-In All-Refrigerator, ADA Compliant

User Manual - Page 7

For FF27BSSADA.

PDF File Manual, 14 pages, Read Online | Download pdf file

FF27BSSADA photo
Loading ...
Loading ...
Loading ...
7
7. Remove the screws from the top left and transfer them to the right.
8. Install the top left hinge. (Fig.5)
9. Install the bottom left hinge to the door. Do not over-tighten the screw.
10. Place the door back on the appliance, lining up the top hinge.
11. Install the bottom support bracket. (Fig.6)
12. Adjust door alignment. When set, tighten the screw on the hinge.
13. Remove the handle. Transfer the screw hole covers to the left and install the handle on the right.
NOTE: Some variations of this unit's door may not be reversible in the field. For more information, visit
our website.
OPERATION
The appliance should be placed where the ambient temperature is between 50~100°F (10~38°C). If the
ambient temperature is above or below this range, the performance of the unit may be affected. Placing
your unit in extreme cold or hot conditions may cause interior temperatures to fluctuate.
Connect the power cord to a properly grounded outlet.
This appliance is equipped with Memory IC should there be a power interruption, the unit will auto-recover
at the last setting.
Control Panel:
Setting the Temperature Control
Adjustable temperature: 36°F to 46°F (2°C to 8°C)
Set the desired temperature by pressing the corresponding buttons, to increase or to decrease.
Each press is a 1-degree increment. Once released, the set temperature will flash for approximately 5
seconds then revert to display the internal temperature.
To view your set temperature, press either the or button once and the LED display will flash the set
temperature for 5 seconds.
The appliance has the capability to display temperature in either Celsius or Fahrenheit. To change the
temperature scale, press and hold both buttons simultaneously for approx. 3 seconds.
Note: The temperature inside may vary slightly depending on whether or not the interior bulb is ON or OFF and
where the bottles are located (upper/middle or lower section).
ECO mode:
Press and hold the button
for 3 seconds, it can enter or exit ECO mode.
Loading ...
Loading ...
Loading ...