Loading ...
Loading ...
Loading ...
19
SURFACE CLEANING
- Unplug the appliance before cleaning.
- Clean the unit surface with a wet soft cloth and do not use chemical solvents such as alcohol and gasoline to avoid any
damage to the unit. Any thinner, alcohol-glazer, or other similar solvents are prohibited for unit cleaning.
- Clean the dirty air outlet or louvers with a wet soft cloth and detergent. Any chemical solvent is prohibited to use for unit
cleaning or putting such things near the unit for a long time.
FILTER CLEANING
- Clean the filter once every two weeks, or it would influence the unit function if the filter is clogged with dust.
- Grip the filter handle and pull it out gently in the correct direction. Clean the dirty particles in the filter with a cleaner if it
is necessary. Immerse and wash the filter gently into warm water (about 40℃) mixed with a neutral cleaner, and then rinse
and dry them thoroughly in the shade.
Notes:
- Pull out the filter gently.
- Removal of the filter at the back panel is a priority over the filter at the side panel, to avoid any twist or damage to the
filter.
- Do not squash or hit the mesh with sharp objects or a brush.
- Do not use the appliance without installing the filter.
INTERNAL WATER TANK
The Water Full indicator illuminates when the internal water has been filled with condensate water.
To Empty the Internal Water Tank:
1. Unplug or disconnect the power.
2. Place a shallow 1 quart or larger pan (not included) below the lower drain located on the back (near the bottom) of the
air conditioner.
3. Remove the cap and the rubber plug and drain the water tank.
4. Re-insert the drain plug and screw the cap snugly into place.
5. Plug in or reconnect power.
STORAGE
Please store the air conditioner properly if not in use.
1. Screw off the drain cover and pull out the stopper to drain the condensate water completely. Or tilt the unit to drain the
water.
2. Keep the unit running in fan mode for half day to dry inside of the unit completely to prevent it from going moldy.
3. Turn off the unit, pull out the plug then wrap the power cord around the wire-winding pillar, insert the plug into the
universal fixing hole at the back panel of the unit, and install the water stopper and drain cover.
4. Remove the heat exhaust hose to assemble, clean, and keep it properly.
5. Take out the batteries from the remote controller and place them in the remote control box.
Note:
Assure the unit is stored in a dry place. All accessories of the unit shall be protected together properly. Keep the unit away
from children.
Handle position
Handle position
Handle position
Handle position
Loading ...
Loading ...
Loading ...