Loading ...
Loading ...
Loading ...
page 8
9. Light Kit Assembly.
Remove 1 screw from motor plate on underside of
motor housing and partially loosen the other 2
screws.
Connect WHITE wire from LED light kit to WHITE
wire from motor housing. Connect BLACK wire
from LED light kit to BLUE (or BLACK) wire from
motor housing. Be sure that molex connections
snap together completely. [Refer to diagram 1.]
Align slotted holes in center of LED light kit with
loosened screws in motor plate. Twist LED light kit
to lock. Re-insert screw that was previously
removed and securely tighten all 3 screws with a
Phillips screwdriver. [Refer to diagram 1.]
Locate slots on shade and align with nodules on
inside of LED light kit. Gently push up on shade and
turn to the RIGHT (clockwise) until it slides
completely into place. [Refer to diagram 2.]
NOTE: Pull down VERY GENTLY on shade to
make sure that shade is secure.
battery
cover
remote control
transmitter
(backside)
battery
10. Remote Control Operation.
If you wish to use the remote control bracket, install
screws, included in remote pack, through bracket
and into the desired installation site. The remote
control transmitter rests inside the bracket.
CAUTION: The remote control transmitter can be
programmed to multiple receivers or fans. If this is
not desired, turn wall switch o to any other
programmable receiver or fan.
Remove battery cover from back of remote control
transmitter. Install one 12-volt battery, size A23,
(included) with positive (+) end toward top of
remote control transmitter. Replace battery cover.
WARNING: Choking Hazard - Small parts. Keep
battery away from children.
["Remote Control Operation" continued on next
page.]
remote control bracket
wall
bracket
screws
motor
housing
motor plate
diagram 2
LED light kit
LED light kit
motor housing
shade
slot
diagram 1
molex
connections
nodule
Loading ...
Loading ...