Loading ...
Loading ...
Loading ...
page 6
5. Fan Assembly. (cont.)
With the hanging bracket secured to the outlet
box and able to support the fan you are now
ready to hang your fan. Grab the fan rmly with
two hands. Slide downrod through opening in
hanging bracket and let hanging ball rest on the
hanging bracket. Turn the hanging ball slot until
it lines up with the hanging bracket tab.
WARNING: Failure to align slot in hanging ball
with tab in hanging bracket may result in
serious injury or death.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you
once you are set on the ladder.
6. Wiring.
WARNING: Turn o circuit breakers to current
xture from breaker panel and be sure switch
is turned to the OFF position.
CAUTION: Be sure outlet box is properly grounded
and that a ground wire (GREEN or Bare wire) is
present.
Make sure all electrical connections comply
with Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with
electrical wiring or if the house/building wires are
dierent colors than those referred to in the
diagram to the right, please use a qualied
electrician.
Wire the receiver with wire connectors provided
as shown in diagram at right.
Tip: While you are wiring, keep in mind
that wires must not obstruct receiver from
sliding into hanging bracket.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
Insert receiver into hanging bracket (at side up)
and gently push taped wire connectors into
outlet box. Allow antenna from remote control
receiver to hang out of the hanging bracket.
hanging ball slot
hanging bracket tab
motor housing
white supply wire
black supply wire
black
black
white
blue
blue
white
from receiver
black
AC IN L
AC IN N
white
white
ground (green
or bare)
from fan
from receiver
antenna
from ceiling
receiver
ground
(green or bare)
black
Loading ...
Loading ...
Loading ...