Loading ...
Loading ...
Loading ...
15
- NAT Gas / LPG / Butane Only.
NOTE:
The regulator supplied is convertible between
Natural Gas and LP Gas, but it’s outlet pressure is
fixed ex-factory and is NOT to be adjusted.
1. Ensure the gas supply is turned 'Off' at the mains.
2. Unscrew hex cap (23mm A/F) from the
regulator.
3. Un-clip the plastic pin from the cap, reverse the
pin and re-fit it back into cap the correct way
for the gas type to be used. (Either ‘LP’ or ‘NAT’
should be visible on flank of the pin once
re-fitted to the cap).
4. Screw cap back into regulator, hand tight only.
- Town Gas Only.
1. Unscrew and remove slotted cap from regulator.
2. Turn on the gas supply and the appliance.
3. Adjust the pressure adjusting nut to achieve the
correct burner operating pressure.
NOTE:
Measure operating pressure at manifold test point
with 2 burners operating at the “High Flame” setting.
4. Verify the operating pressure remains correct
(Re-adjust the regulator if required).
5. Screw the cap nut back onto the regulator.
NOTE, Pin rotated
for Natural Gas
NOTE, Pin rotated
for LPG
Pressure Adjusting
Screw
Cap Nut
On completion of the gas conversion, replace the
gas type labels located at:-
- The rear of the unit, above the gas
connection.
- Beside the rating plate.
Before leaving the converted installation;
1. Check all gas connections for leakages using
soapy water or other gas detecting equipment.
2. Check the following functions in accordance
with the operating instructions specified in the
“Operation” section of this manual.
Light the Main Burners.
Check the Low Fire Burner Operation.
Check the High Fire Burner Operation.
Ensure that all the Controls operate correctly.
Ensure that the Operating Pressure remains
correct.
NOTE:
If for some reason it is not possible to get the
appliance to operate correctly, shut off the gas
supply and contact the supplier of this appliance.
DO NOT USE A NAKED FLAME TO CHECK FOR GAS LEAKAGES.
Loading ...
Loading ...
Loading ...