Loading ...
Loading ...
Loading ...
25
Hose and cable lengths
Left-hand connection or Right-hand connection
Water connection
– To prevent leaks or water damage, you must observe the instructions
in this section.
– Caution: Only operate the washing machine using cold drinking water.
– Do not connect to the mixer tap of an unpressurised hot-water boiler.
– If in doubt, have a technician connect the appliance.
– Do not use a used inlet hose. Only use the inlet hose supplied or one
that was purchased from an authorised specialist retailer.
– The water supply and drain hoses can be routed to the left or right,
depending on installation conditions.
Water supply
Do not allow the water supply hose to be:
– bent, squashed, modified or cut through
(otherwise its strength is no longer guaranteed).
Note the water pressure in the mains supply:
– The water pressure should be between 50-900 kPa (0.5-9 bar) (at least
8 litres of water flow out per minute when the tap is turned on).
– If the water pressure is higher than this, a pressure reducing valve
must be installed.
Connect the supply hose to the cold water tap with ¾" connection.
Only tighten the screw connections by hand. Do not remove the filter from
the supply hose.
After connecting the water supply hose:
– Open the water tap carefully, checking the leak tightness of the
connection points.
– Caution: The screw connection is under mains water pressure.
Loading ...
Loading ...
Loading ...