Loading ...
Loading ...
Loading ...
Operation
Owner’s Manual for 60 Hz Air-Cooled Generators 15
Section 3: Operation
Site Prep Verification
Generator must be installed to allow unimpeded airflow
into and out of generator.
Mechanical and gravity outdoor air intake openings for air
distribution and supply systems must be located not less
than 10 ft (3.05 m) horizontally from generator enclosure.
See Section 401.4 in the ICC Mechanical Code for addi
-
tional information.
Verify all shrubs or tall grasses within 3 ft (0.91 m) of
intake and discharge louvers on the sides of the enclo
-
sure have been removed. Install generator on high
ground where water levels will not rise and endanger it.
This unit must not operate in or be subjected to standing
water. Verify all potential water sources such as water
sprinklers, roof run-off, rain gutter downspouts, and sump
pump discharges are directed away from unit.
Generator Enclosure
Enclosure lid is locked prior to shipment. A set of keys is
attached to cardboard on top of generator. An additional
set of keys is attached to pallet bracket on the front intake
end of generator.
NOTE: Keys provided with this unit are intended for ser-
vice personnel use only.
Opening the Lid
1. Use keys to open generator lid.
2. See Figure 3-1. Two locks (A) secure lid; one on
each side. Open protective rubber cap to access
keyhole.
Figure 3-1. Opening the Lid
3. Press down on lid above side lock, and unlock
latch to correctly open lid.
4. Repeat for other side. Lid may appear stuck if pres-
sure is not applied from the top.
NOTE: Always verify side locks are unlocked before
attempting to lift lid.
Front Access Panel Removal
See Figure 3-2. Remove front access panel (A) by lifting
straight up and out once lid is open.
Figure 3-2. Remove Front Access Panel
(000191)
DANGER
Automatic start-up. Disconnect utility power and
render unit inoperable before working on unit.
Failure to do so will result in death or serious injury.
009209
A
A
009210
A
B
C
D
Loading ...
Loading ...
Loading ...