Loading ...
Loading ...
Loading ...
If the plate is set to the stop position, large dishes
can be placed on the entire surface of the oven.
In this case you will need to manually turn the
container or mix its contents mid-program.
1.5 OPERATING PRINCIPLES
Microwaves used for cooking are electromagnetic
waves. They are commonly found in our
environment in the form of radio waves, light, or
infrared radiation.
Their frequency is in the 2450 MHz band.
This is how they work:
• They are reected by metals.
• They pass through any other material.
• They are absorbed by water, fat and sugar
molecules.
When food is exposed to microwaves, this results in
a rapid agitation of its molecules, which makes the
food heat up.
The depth of penetration of the waves into the food
is about 2.5 cm. If the food is thicker, cooking at
its centre occurs by conduction just like traditional
cooking.
In essence, microwaves are simply causing a
thermal change inside the food and are therefore
not harmful to health.
2.1 UNPACKING
When you receive the appliance, unpack it or
have it unpacked immediately. Check its general
appearance. Make a note of any reservations
on the delivery slip and keep a copy. Remove
all protective packing. Check and follow the
appliance’s specications which are listed on the
data plate (2.1.1)
2.2 CHOICE OF LOCATION AND FITTING
This appliance must be installed in a cabinet
column as shown in the installation diagram (2.2.1
to 2.2.3).
Do not use your appliance immediately (wait for
about 1 to 2 hours) after transferring it from a cold
place to a warm place, as condensation may cause
a malfunction.
Centre the oven in the cabinet so as to ensure
a minimum distance of 10 mm between the
appliance and the surrounding unit. The material
of the cabinet supporting the appliance must be
heat resistant (or covered with a heat-resistant
material).
For greater stability, attach the oven to the unit
with 2 screws through the holes provided in the
side panels.
2.3 ELECTRICAL CONNECTION
Warning:
Installation should only be performed by
qualied installers and technicians.
The appliance must be recess-tted correctly to
ensure electrical safety. The electrical connections
should be made before the appliance is installed in
its housing.
Ensure that:
- the circuit has sucient power (16 Amps).
Warning:
The safety wire (green-yellow) is
connected to the appliance’s terminal and
must be connected to the installation’s
earth.
If the oven malfunctions in any way, unplug
it or remove the fuse for the circuit where the
oven is installed.
We cannot accept liability for any accident
or incident resulting from non-existent,
defective or incorrect grounding.
If the electrical installation of your home
requires a modication to connect the
appliance, call a qualied electrician.
During maintenance, the appliance must be
disconnected from the mains, the fuses must
be switched o or removed.
Installation
2
ENGLISH
Loading ...
Loading ...
Loading ...