Loading ...
Loading ...
Loading ...
19
E
Accessories
The laser is equipped with both 1/4 - 20 and 5/8 - 11
female threads on the bottom of the unit
(Figure
J
). This thread is to accommodate current
or future D
e
WALT accessories. Only use
DeWALT
accessories specied for use with this product. Follow
the directions included with the accessory.
WARNING:
Since accessories, other than those offered
by
DeWALT
, have not been tested with this
product, use of such accessories with this
tool could be hazardous. To reduce the
risk of injury, only D
e
WALT recommended
accessories should be used with this product.
f you need any assistance in locating any accessory,
please contact your nearest D
e
WALT service center or
go to www.D
e
WALT.com.
Target Card
Some laser kits include a Laser Target Card (Figure
L
)
to aid in locating and marking the laser beam. The
target card enhances the visibility of the laser beam as
the beam crosses over the card. The card is marked
with standard and metric scales. The laser beam
passes through the red plastic and reflects off of the
reflective tape on the reverse side. The magnet at the
top of the card is designed to hold the target card to
ceiling track or steel studs to determine plumb and level
positions. For best performance when using the Target
Card, the
DeWALT
logo should be facing you.
Laser Enhancement Glasses
Some laser kits include Laser En hancement Glasses
(Figure
M
). These glasses improve the visibility of
the laser beam under bright light conditions or over
long distances when the laser is used for interior
applications. These glasses are not required to operate
the laser.
CAUTION:
These glasses are not ANSI approved
safety glasses and should not be used while
operating other tools. These glasses do not
keep the laser beam from entering your eyes.
CAUTION:
To reduce the risk of serious injury, never stare
directly into the laser beam with or without
these glasses.
Ceiling Mount
The laser ceiling mount (Figure
K
1
), if included, offers
more mounting options for the laser. The ceiling mount
has a clamp (Figure
K
2
) at one end which can be xed
to a wall angle for acoustic ceiling installation
(Figure
K
3
). At each end of the ceiling mount is a
screw hole (Figure
K
4
and
K
5
), allowing the ceiling
mount to be attached to any surface with a nail or screw.
Once the ceiling mount is secured, its steel plate
provides a surface to which the magnetic pivot bracket
(Figure
K
6
) can be attached. The position of the
laser can then be ne-tuned by sliding the magnetic
pivot bracket up or down on the wall mount.
Service and Repairs
NOTE: Disassembling the laser level(s) will void all
warranties on the product.
To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment should be performed by
authorized service centers. Service or maintenance
performed by unqualied personnel may result in a risk
of injury. To locate your nearest
DeWALT
service center
call 1-800-4-
DeWALT
(1-800-433-9258) or go to www.
DeWALT
.com.
Warranty
Go to www.D
eWALT
.com for the latest
warranty information
Loading ...
Loading ...
Loading ...