Loading ...
Loading ...
Loading ...
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
Temp Temp System
Minus On!Off Plus Lock Status
keypad keypad keypad Display Area keypad indicators
::::::::::::::::::::::::::::::::::::::::::
Electronic Control Display
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
To wake the display press any keypad, A
_Wl_ _ confirm tone will sound, and the current
storage compartment temperature will be
displayed,
Star_ing your appliance," ____
Plug the appliance power cord into a 115
volt wall outlet, Your appliance is shipped
from the factory in the "On" position and _
will begin start-up of cooling as soon as
power is supplied, if the appliance does
not start, confirm that the wall outlet has The sleep mode can be disabled if you
power, and that the control is in the "On" prefer to have the display on continuously.
position, (See "Turning your appliance On Press and hold the "Lock" keypad until the
and Off" below), display goes past "Loc" and reads "nSL",
The control display is covered with a clear To enable the sleep mode, repeat the
plastic film. This film may be removed by instruction, again going past "hoc" until the
carefully lifting the film at a corner, display reads "SLP".
On initialpower up, the control display will
indicate a "Power Failure"alarm. This is
a normal condition as the appliance was _ __
powered-up at the factory for quality inspection
and then removed from power. A momentary
press ofthe "On/Off" keypad will reset this Turning your appliance ON arid OFF:
alarm condition.
(See
Alarms
section).
if the appliance is "On", (and out of sleep
mode) the temperature will be shown in
the display area of the control, To turn the
appliance "Off", press and hold the "On/
Off" keypad for four seconds. "OFF" will
now be displayed on the control,
O ..........................................
S eepmode:
If no keypads are pressed for 60 seconds,
the display will enter sleep mode to
conse epower.Thecontro pane wi,
go dark with the exception of the system To turn the appliance "On", press and hold
status "OK" indicator which will remain the "On/Oft" keypad for four seconds,
enabled. Alarm conditions will wake the
display, (SeeAlarms section).
To make the following changes to the
control settings (turning the appliance ON/
OFF, adjusting the temperature, changing
the interior lights, and activating vacation
mode), the control must be awake,
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
Loading ...
Loading ...
Loading ...