Loading ...
Loading ...
Loading ...
16
PROBLEM CAUSE SOLUTION
If you want to change the type of coee You must remove all the beans present
in the machine
• Empty the beans container (if neces-
sary, operate the coee mill without
beans or use a vacuum cleaner to re-
move any remaining beans)
• Attach the lter holder and operate
the coee mill a number of times
without beans to free the coee guide.
Attach the lter holder to the outlet
of the grinder (A18), lining it up with
"INSERT", then turning it to the right.
Grinding begins when the lter holder
reaches the CLOSE position and stops
automatically. Repeat until the lter is
empty
• Place the new coee in the beans
container
• If the amount of coee ground is not
enough to reach the perfect dose, pro-
ceed setting the appliance as for the
rst use
After grinding, the coee lter is empty The coee grinder coee funnel is
clogged
Clean as described in section “5.10 Cleaning
the “Smart tamping station””. If the problem
persists, access the guide by opening the hatch
and free it using the brush)
After grinding, there is too much coee
in the lter
After grinding, the ground coee in the
lter does not reach the “perfect dose”
The "Smart Tamping Station" needs
cleaning
Clean as described in section “5.10 Cleaning
the “Smart tamping station”, then grind again
The quantity of ground coee needs
adjusting
Adjust the quantity of coee with the dial
(B2). If the dial is already in the max. position,
proceed as described in section “Extra grinding
adjustment”
Over time the burrs wear down
Replace the burrs as described in section “5.9
Replacing the burrs”