Loading ...
Loading ...
Loading ...
BRISTLE BRUSH ATTACHMENT — BBA2100/BBA2100-FC 17
CONNECTING THE BRISTLE BRUSH ATTACHMENT TO THE POWER
HEAD
WARNING:
Never attach or adjust any attachment while the power head is
running or with the battery installed. Failure to stop the motor and remove the battery
may cause serious personal injury.
This bristle brush attachment is designed for use with EGO Power Head PH1400/
PH1400-FC.
The bristle brush attachment connects to the power head by means of a coupler
device.
1. Stop the motor and remove the battery pack.
2. Loosen the wing knob on the power head coupler.
3. If the end cap is on the attachment shaft, remove it and reserve it for later use.
Align the arrow on the bristle brush shaft with the arrow on the coupler (Fig. 9a)
and push the bristle brush shaft into the coupler until you hear a clear “CLICK”
sound. The coupler should be positioned all the way to the RED LINE labeled on
the shaft: until the red line mark is ush with the coupler edge (Fig. 9b).
4. Pull on the shaft of the bristle brush attachment to verify that it is securely locked
into the coupler. If not, rotate the bristle brush shaft from side to side in the
coupler until a clear “CLICK” sound indicates that it is engaged.
5. Tighten the wing knob securely.
WARNING:
Be certain the wing knob on the coupler is fully tightened before
operating the equipment; check it periodically for tightness during use to avoid serious
personal injury.
Loading ...
Loading ...
Loading ...