Loading ...
Loading ...
Loading ...
en Troubleshooting
56
Fault Cause and troubleshooting
The water is not drain-
ing.
–––– is activated.
▶
Continue the programme by selecting
or and
pressing Inicio/Pausa+ Carga .
→"Resuming the programme when the programme
status is Rinse Hold", Page40
The water outlet hose is connected too high.
▶
Install the water outlet hose at a maximum height of
1 metre.
Detergent dosage is too high.
▶
Immediate measure: Mix one tablespoon of fabric
softener with 0.5 litres of water and pour the mix-
ture into the compartment for manual dosing (not
for outdoor clothing, sportswear or items stuffed
with down).
▶
If intelligent dosing is activated, reduce the basic
dosage →Page42.
▶
If you dose manually, reduce the amount of deter-
gent for the next washing cycle with the same load.
Unapproved extension installed on the water drain
hose.
▶
Remove any unapproved extensions from the water
hose. Connecting the appliance
Water is not flowing
in. Detergent is not
being dispensed.
You have not pressedInicio/Pausa+ Carga .
▶
Press Inicio/Pausa+ Carga
.
The filters in the water inflow are blocked.
▶
Clean the filters in the water inflow →Page50.
The tap is turned off.
▶
Turn on the tap.
The water inlet hose is kinked or jammed.
▶
Ensure that the water inlet hose is not kinked or
jammed.
The spin cycle runs
several times.
The unbalanced load detection system eliminates an
imbalance by repeatedly redistributing the laundry.
▶
Not a fault – no action required.
Note:When loading, where possible, place large and
small items of laundry together in the drum. Different
sized items of laundry distribute themselves better
during the spin cycle.
The programme dura-
tion changes during
the wash cycle.
The programme operation is optimised electronically.
This may change the programme duration.
▶
Not a fault – no action required.
Loading ...
Loading ...
Loading ...