Loading ...
Loading ...
Loading ...
INSTALLATION - 4391477A305/B
e
2. Select VAPOR CLEAN .
Vapor Clean cleaning stage
3. Touch the START button to start the
Vapor Clean function.
This stage is indicated by a progressive increase
in cooking.
End of Vapor Clean
At the end of the Vapor Clean function,
"Function ended" is shown on the display and a
buzzer sounds briefly, which can be
deactivated by touching any point of the display
or by opening the door.
1. Touch the HOME button to exit from
the function.
2. Open the door and wipe away the less
stubborn dirt with a microfibre cloth.
3. Use a non-scratch sponge with brass
filaments on hard to remove deposits.
4. In case of grease residues use specific oven
cleaning products.
5. Remove any remaining water from the oven
cavity.
6. Where fitted, reposition the self-cleaning
panels and the rack/tray support frames.
For greater hygiene and to avoid foods taking
on unpleasant odours:
• we recommend drying the inside of the oven
with a fan-assisted function at 160°C for
around 10 minutes.
• Where the self-cleaning panels are fitted,
we recommend drying the oven cavity with
a simultaneous catalytic cycle.
Extraordinary maintenance
Seal maintenance tips
The seal should be soft and elastic.
• To keep the seal clean, use a non-abrasive
sponge and wash with lukewarm water.
INSTALLATION
Electrical connection
General information
Check the mains characteristics against the data
indicated on the plate.
The identification plate bearing the technical
data, serial number and brand name is visibly
positioned on the appliance.
Do not remove this plate for any reason.
The appliance must be connected to ground
using a wire that is at least 20 mm longer than
the other wires.
The appliance can work in the following modes:
• 220-240 V~
3 x 1.5 mm² three-core cable.
Fixed connection
Fit the power line with an all-pole circuit breaker
with a contact separation distance sufficient to
provide complete disconnection in category III
We recommend wearing rubber gloves
for these operations.
For easier manual cleaning of parts that
are difficult to reach, we recommend
removing the door.
See General safety instructions.
The values indicated above refer to the
cross section of the internal lead.
The aforementioned power cables are
sized taking into account the
coincidence factor (in compliance with
standard EN 60335-2-6).
Loading ...
Loading ...
Loading ...