Loading ...
Loading ...
Loading ...
AMantenna
1
2
ConnectingSpeakers
FM75Q
COAXIAL
Vinyl-covered wire
(not supplied)
5
AM loop antenna
(supplied)
1 If the cords are covered with insulation,
remove a short section of insulation at the
end of each cord by twisting and pulling it
off.
2 Press and hold the clamp of the AM LOOP
terminals on the rear of the unit.
3 Insert the AM loop antenna to the AM LOOP
terminals as illustrated.
4 Release your finger from the clamp.
5 Turn the AM loop antenna until you have the
best reception.
ToconnectanoutdoorAMantenna
When z_ception is poor, connect a single vinyl-covez_d wile
to lhe AM EXT lerminal and extend it horizontally. The AM
loop antenna must remain connected.
_For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other terminals
and connecting cords.
• Keep the antennas away from metallic parts of the unit, connecting
cords, and the AC power cord.
1
2
Speaker cords Speaker cords
(black/blue) (black/blue)
® ®
IMPED
Speaker cords
(black/red)
From right From left
subwoofer subwoofer
terminal terminal
From right main
speaker terminal
From left main
speaker terminal
If the cords are covered with insulation,
remove a short section of insulation at the
end of each cord by twisting and pulling it
off.
2 Insert the end of the speaker cord into the
terminal as illustrated.
Match the same polarity: (+) to (+) and (-) to (-).
3 Close the speaker terminals.
I IMPORTANT: Use only speakers with the same speaker I
I
impedance as indicated by the speaker terminals on the
I
rear of the unit.
i_• DO NOT connect more than one speaker to
each speaker terminal.
• DO NOT push or pull the speakers as this will
damage the foot spacers at the bottom of the
speakers.
7
Loading ...
Loading ...
Loading ...