Loading ...
Loading ...
Loading ...
Follow Winterizing
Instructions for cold
weather care.
Winterizing Instructions
Ifthe laundrycenter isstored in an areawhere freezing ran occur or moved in freezing
temperatures, follow these winterizing instructions to prevent damageto the laundry
center:
1. Turn off water supply faucets,
2, Disconnect hosesfrom water supply and drain water from hoses,
3, Plug electrical cord into a properly grounded electrical outlet,
4, Add 1 gallon nontoxic recreational vehicle (RV)antifreeze to empty wash drum,
Close door,
5, Set cycle selector knob at aspin setting, Pull out knob and let washer spin for
1 minute to drain out all water, Not all of the RVantifreeze will be expelled,
6, Pushin knob, unplug electrical power cord, dry,tub interior, and close door,
7, Store washer in an upright position,
8, To remove antifreeze from washer after storage, run empty washer through a
complete cycle using detergent, Do not add wash load.
Avoid Service Checklist
Before calling for service, review this list. It may save both time and expense, The list includes common concerns that are not the
result of defective workmanship or materials in this laundry center,
POSSIBLE CAUSE / SOLUTION
"Clicking" noise. , A normal sound made by the timer.
High pitch 'Jet engine" noise. , A certain amount of motor whine isnormal during the spin cycle.
Rattling and clanking noise. , Foreign objects such ascoins or safety pins may be in drum or pump, Stop washer
and check drum. If noise continues after washer isrestarted, objects may be in
pump, Call your authorized servicer.
, Belt buckles and metal fasteners are hitting wash drum, To prevent unnecessary
noise and damage to drum, faster] fasteners and turn items inside out,
Squealing sound or hot rubber odor. , Washer isoverloaded. Do not overload washer. Stop washer and reduce load.
Thumping sound. , Heavywash loads may produce athumping sound. This isusually,normal. Ifsound
continues, washer is probably out of balance. Stop washer and redistribute wash
load.
Vibrating noise. , Washer isnot resting firmly onfloor. Move washer soit restsfirmly or]floor. Adjust
leveling legs. See INSTALLATIONINSTRUCTIONSfor details.
, Shipping bolts and foam block have not been removed during installation, See
INSTALLATIONINSTRUCTIONSfor removing shipping bolts and foam block.
, Wash load unevenly distributed in drum, Stop washer and rearrange wash load,
14
Loading ...
Loading ...
Loading ...