Loading ...
Loading ...
Loading ...
!
6!
2. Insert the handle (Fig. 3/1) into the upper end of
the telescopic tube (Fig 3/2).
3. Attach the floor nozzle (Fig. 3/3) to the bottom
end of the telescopic tube (Fig 3/4).
NOTE: Shove all the way together and firmly twist to the
right to connect pieces.
4. Adjust the length of the telescopic tube. Press down the
release latch on the tube to do this (Fig. 4/1). Then pull the
handle of the telescopic tube to extend it to your desired length
(Fig. 3/1). Let go of the release catch while pulling until it
locks in place. You will hear a distinct click.
Your vacuum cleaner is now ready for use.
Using Accessories & Tools
Besides the floor nozzle you just attached, the Prolux TerraVac is
also equipped with on board Tools as shown in Figure 5.
The combi brush (used for upholstery & dusting) and the crevice
nozzle are stored on board under the lid. You can store them in the
accessory compartment when not in use (fig.5).
WARNING: Only attach nozzles when the vacuum cleaner is not
connected to the electrical outlet. The appliance could be switched
on by accident.
- Combi brush (Fig. 6/1) Use this to remove dust from objects with delicate surfaces
and upholstery.
-Crevice nozzle (Fig. 6/2) Use this to suck dust out of hard to reach places.
This is how you attach the nozzles:
1. Switch off the vacuum cleaner and pull the plug from the outlet.
2. Remove the attached nozzle off of the telescopic tube.
3. Attach the required nozzle to the bottom end of telescopic tube (Fig. 7) or if
necessary directly to the handle.
ATTENTION: Using the vacuum cleaner without a nozzle attached increases the
danger of accidentally sucking in objects.
Loading ...
Loading ...
Loading ...