Loading ...
Loading ...
Loading ...
TROUBLESHOOTING
Problem Possible Causes What to Do
Technical
Problems
Dishwasher does
not start
Fuse blown or circuit
breaker tripped.
Replace fuse or reset circuit breaker. Remove any other ap-
pliances sharing the same circuit with the dishwasher.
Power supply not
turned on.
Make sure the dishwasher is turned on and the door is
closed securely. Make sure the power cord is properly
plugged into the wall socket.
Door of dishwasher
not properly closed.
Close door completely and make sure it is latched.
Water not
pumped from
dishwasher
Kink in drain hose. Check drain hose.
Filter is clogged. Check filter system.
Kitchen sink clogged.
Check sink to make sure it is draining well. If sink is clogged,
you may need a plumber.
General
Problems
Suds in the tub
Improper detergent.
Use only dishwasher detergent to avoid suds. If this occurs,
open the dishwasher and let suds evaporate. Add
1 gallon of cold water to the tub. Close and latch the door
then Start the “Rinse” wash cycle to drain out the water.
Repeat if necessary.
Spilled Rinse Aid. ALWAYS wipe up rinse-aid spills immediately.
Stained tub
interior
Detergent with color-
ant was used.
DO NOT use detergents with colorants or dyes.
White film on
inside surface
Hard water minerals.
To clean the interior, use a damp sponge with dishwasher de-
tergent and wear rubber gloves. Never use any other cleaner
than dishwasher detergent for the risk of foaming or suds.
Rust stains on
cutlery
Cutlery is not corro-
sion resistant.
Only put corrosion resistant items in the dishwasher.
A program was not
run after dishwasher
detergent was added.
Traces of detergent
have gotten into the
wash cycle.
Run the Quick Wash program without any dishes or utensils
in the dishwasher after adding dishwasher detergent.
Noise
Knocking noise
inside the wash
cabinet
The spray arm is
hitting an item in the
basket.
If you are able to, interrupt the program and rearrange the
items which are obstructing the spray arm.
If you are unable to interrupt the program, fix the spray arm
position after cycle is complete.
Rattling noise in
the wash cabinet
Item inside is loose.
If you are able to, interrupt the program and rearrange items
in the dishwasher.
Knocking
noise in
the water pipes
This may be caused by
on-site installation or
the cross-section of
the piping.
This has no influence on dishwasher function.
If in doubt, contact a suitably plumber.
Unsatisfactory
Washing
The dishes are
not clean
Dishes not loaded
correctly.
Make sure dishes are loaded correctly per the “Loading the
Dishwasher” section.
21
Loading ...
Loading ...
Loading ...