Loading ...
Loading ...
Loading ...
10
a. Power Cord
b. Inlet Port
c. Drain Port
d. Inlet Port Connection
e. Quick Connect Connection
f. Drain Port Connection
g. Quick Connect Connection
h. Faucet Adapter
i. Faucet Washer
j. Pressure Relief Valve
k. Faucet Adapter Connection
l. Locking Collar
m. Inlet Hose Connection
n. Drain Hose Connection
1. Screw the faucet adapter (Figure 4, h) onto or into the faucet tap, depending on the style of the faucet. Check
for leaks (use Teflon tape to eliminate if necessary).
2. Connect the drain port connection side of the drain hose (Figure 4, f) to the drain port on the back of the
dishwasher (Figure 4, c). Be careful not to over-tighten (to avoid damaging the threads).
3. Connect the inlet port connection side of the water inlet hose (Figure 4, d) to the inlet port on the back of
the dishwasher (Figure 4, b). Be careful not to over-tighten
(to avoid damaging the threads).
4. Connect the quick connect side of the drain hose (Figure 4, g) onto the longer (bottom) male connection on
the quick connect (Figure 4, n).
5. Connect the quick connect side of the inlet hose (Figure 4, e) onto the shorter (top) male connection on the
quick connect (Figure 4, m).
6. Attach the quick connect onto the faucet adapter by pulling the outer locking collar on the quick connect
(Figure 4, k) down while pushing the quick connect upward onto the faucet adapter.
7. When the quick connect snaps onto the faucet adapter, release the locking collar. Verify the connection is
secure.
8. Slowly open the hot water line and check all connections for any sign of water leakage. If leaks are located,
immediately close the water supply and repair the hose connections.
NOTE: Once you open the water supply line, (even if it is closed immediately thereafter), the inlet hose will be
pressurized. To relieve water pressure from inside the inlet hose, first make sure the water line is closed, and then
press and hold the red pressure relief button on the quick connect (Figure 4, j) until the flow of water stops.
WARNING: Failure to relieve water pressure before disconnecting the quick-connect from the faucet will result
in back-pressure causing the water to spray. The temperature of incoming water can be very hot and could cause
severe burns and/or scalding.
WARNING: DO NOT let children disconnect the dishwasher. Close supervision of children is ALWAYS important
around the appliance.
DISCONNECTING THE WATER
1. Shut off the water supply at the faucet.
2. Relieve water pressure from the hose using the red relief release button.
3. Unplug the dishwasher by firmly grasping the plug and pulling straight out from the outlet.
4. Let water drain from water inlet hose.
Loading ...
Loading ...
Loading ...