Loading ...
Loading ...
Loading ...
1) Before cleaning, be sure to disconnect the unit from any electric supply outlet;
2) Do not use gasoline or other chemicals to clean the unit;
3) Do not wash the unit directly;
4) If the conditioner is damaged, please contact the dealer or repair shop.
Cleaning the air filter every two weeks will keep in unit running in top condition with optimum
cooling eciency.
Before you clean: unplug the unit.
1. Open the upper air inlet grille and remove air filter.
2. Clean the air filter with mild or diluted detergent in lukewarm（40℃/104℉）water. Rinse well and
allow to air dry.
3. Return air filter to original position and replace the upper grille.
Clean housing surface with a mild detergent applied to wet cloth and wipe with a soft dry cloth.
1. Completely drain unit system according to steps found in the “WATER DRAINAGE” section.
2. Complete air filter cleaning as above.
3. Run unit in FAN mode for 15-20 minutes
4. Return drain spouts to snug position.
5. Clean housing as above and store unit.
Cleaning
the
Air Filter
Cleaning the
Housing
Storage
Maintenance
11
maintenance
3
2
1
Method 1:
Manual
Draining for
Cooling and
Dehumidifier
Mode
Method 2:
Continuous
Draining for
Dehumidifier
Mode
10
When there is excess water condensation inside
the unit during normal cooling operation, the air
conditioner stops running (the fan will continue
running) and the WATER FULL indicator illumi-
nates on the top control panel. This in dicates that
the collected water needs to be drained using
either of the following procedures:
With manual draining, both rear drain spout caps
are tightly sealed during normal operation. The
WATER FULL indicator will illuminate when the
internal water container is lled to the level
when it needs to be emptied.
After turning the unit o, place a shallow pan
under the air conditioner as shown in the
diagram. Remove the lower drain spout rubber
cap and the water will drain from the unit.
Replace the rubber cap on to the drain spout and
power the unit on. The cooling function will
continue a few minutes after powering on.
This method is recommended for DEHUMIDIFIER
MODE. To drain water from the unit continuously
you will need to attach the provided drain hose
to the air conditioner. On the back side there is a
top and a bottom drain spout, each capped with
a rubber stopper. After turning unit o, remove
the top drain spout cap and insert the drain
hose. Position the other end of the drain hose to
a collector tray or towards a drain if that is avail-
able. (If you wish to utilize a drain in your home
you can connect your own standard ¾” hose cut
to the desired length needed.)
Keep in mind that the drain hose should not be
kinked or constrict water ow in any way. The
drain hose end and the collector tray must be at
a lower height than the upper drain spout
connection to the hose. Be sure to use a collector
container that is deep enough to hold at least a
liter of water as the dehumidifying process is
quite eective, and you wouldn’t want to empty
the tray unnecessarily often!
water
drainage
Loading ...